Operation Manual

ManualsBrandsCarlson Wireless Technologies ManualsElectronicsWireless Local Loop Extender (Digital Remote Phone

Carlson Wireless USA revision 1.05 Page 20

CARLSON WIRELESS TELEPHONE, Inc.

CARLSON WIRELESS USA

USA Headquarters:

1150 Evergreen Road

P.O. Box 2400

Redway, CA 95560 USA

Tel: +1 707 923 9593

Fax: +1 707 923 1913

Email sales@wireless-telephone.com

DISTRIBUTED BY:

Publication date – Oct 99

About Carlson Wireless Telephone Inc.

Carlson Wireless Telephone, Inc. was formed in March 1999 as

a privately held corporation based in Redway, California. Carlson

Wireless Telephone (CWT) is dedicated to designing, manufac-

turing and marketing state-of-the-art digital WLL (wireless local

loop) telephone systems that provide high-quality voice and data

for rural and remote telephone users worldwide.

CWT was founded by James Carlson following a 15-month prod-

uct development by a team of engineers at Carlson Engineering

Services (CES), a private engineering design firm. In 1999 CWT

purchased the rights to the digital wireless telephone system de-

signed by CES. CWT will market and manufacture the product,

which has been named "The i-WLL Internet-Ready, All-Digital

Wireless Remote Telephone Link."

CWT is marketing the i-WLL product through established tele-

com and wireless equipment distributors. Please contact our

sales department +1 707 923 9593, or sales@wireless-

telephone.com for more information.

Carlson Wireless USA revision 1.05 Page 1

INSTALLATION & OPERATING MANUAL

MODEL NO. i-WLL-15

Caution! - Please read the sections on Un-

packing, Planning, and Installation before

installing this equipment

Summary of content (20 pages)

PAGE 1
CARLSON WIRELESS TELEPHONE, Inc. CARLSON WIRELESS USA USA Headquarters: 1150 Evergreen Road P.O. Box 2400 Redway, CA 95560 USA Tel: +1 707 923 9593 Fax: +1 707 923 1913 Email sales@wireless-telephone.com MODEL NO. i-WLL-15 About Carlson Wireless Telephone Inc. Carlson Wireless Telephone, Inc. was formed in March 1999 as a privately held corporation based in Redway, California.
PAGE 2
(This page is intentionally left blank.) The employees and shareholders of Carlson Wireless Telephone Inc. wish to thank you for your purchase of the i-WLL product. For more information about the company, see our web site at http://www.wirelesstelephone.com i-WLL, the i-WLL logo , Carlson Wireless USA, and the Carlson Wireless logo are registered trademarks of Carlson Wireless Telephone Inc.
PAGE 3
Carlson Wireless USA Limited Warranty Carlson Wireless Telephone (CWT) or Carlson Wireless USA, Collectively referred to as "Carlson“) will repair this product with new or rebuilt parts, free of charge, in the USA or Puerto Rico for two (2) years from the date of original purchase in the event of a defect in material or workmanship.
PAGE 4
SCOPE OF MANUAL This manual is designed to support the installation, operation and maintenance of the i-WLL–15 All-Digital Remote Wireless Telephone Link. To avoid harm to persons or damage to the product please ensure that you have read through the unpacking and installation sections before proceeding. UNPACKING The i-WLL-15 system will arrive in one box approximately 32 x 16x 9 inches (80 x 40 x 23 cm). Small amounts of feed cable and power supplies may also be included in this box if ordered.
PAGE 5
Consumer and US Regulatory Information Connection to the telephone network 1. The Federal Communications Commission (FCC) has established rules which permits this device to be directly connected to the telephone network. 2. If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until repair has been made. If this is not done, the telephone company may temporarily disconnect service. 3.
PAGE 6
SYSTEM PLANNING PARTS LIST i-WLL-15 Certain requirements are necessary for the i-WLL-15 system to function. (1) A radio path with losses fitting within the capacity of the system. We have a chart showing various antenna and distance combinations . Distance Distance in Miles in km 1.5 2.4 2.0 3.2 5.0 8.0 7.0 11.3 8.0 12.9 8.0 12.9 10.0 16.1 10.0 16.1 12.0 19.3 15.0 24.1 20.0 32.2 25.0 40.2 50.0 80.
PAGE 7
(2) Other users of the 2.400 to 2.483 GHz ISM band. The ISM or Industrial, Scientific, and Medical band, is shared with many other type of services. Fortunately most of the users are located in urban areas, leaving sharing concerns down to consumer microwave ovens and other spread spectrum rural telephone users. The I-WLL-15 system has divided the ISM band into 8 sub-bands or channels.
PAGE 8
INSTALLATION Note that the installation of the FXO and FSO units are similar (1) Connecting the feed cable to the outside unit. On the mounting end of the tube there is an end cap with a weather sealing clamp. This allows the feed cable the penetrate the housing and remain sealed to outside weather. Begin with the removal of the rear end cap by using a coin as a wedge and working your way around the tube until the end cap pops off.
PAGE 9
SPECIFICATIONS BASEBAND PERFORMANCE Voice Coding Signaling Modem Support Fax Support Digital Interface Idle Channel Noise End-to-End System Latency (2) Connecting the feed cable to the inside equipment. Inside the building the feed cable is brought out to a terminal block consisting of 4 pairs of screw down connections. The following diagram shows how to wire the connectors. Uncompressed 64 kb/s PCM DTMF is passed through up to V.34-1996, (33.
PAGE 10
(4) Rough alignment. This is usually easier then it would seem. Since it is a prerequisite that you have line of sight between the two points, here are several ideas that have worked for installers: (1) If you can see the other unit, simply aim the tubes towards each other. (2) During midday, use a large mirror to create a bright reflection approximately towards the other site while someone watches for the flash. (3) Plot out the path on a topo map and set the antennas using a compass.
PAGE 11
(4) Rough alignment. This is usually easier then it would seem. Since it is a prerequisite that you have line of sight between the two points, here are several ideas that have worked for installers: (1) If you can see the other unit, simply aim the tubes towards each other. (2) During midday, use a large mirror to create a bright reflection approximately towards the other site while someone watches for the flash. (3) Plot out the path on a topo map and set the antennas using a compass.
PAGE 12
SPECIFICATIONS BASEBAND PERFORMANCE Voice Coding Signaling Modem Support Fax Support Digital Interface Idle Channel Noise End-to-End System Latency (2) Connecting the feed cable to the inside equipment. Inside the building the feed cable is brought out to a terminal block consisting of 4 pairs of screw down connections. The following diagram shows how to wire the connectors. Uncompressed 64 kb/s PCM DTMF is passed through up to V.34-1996, (33.
PAGE 13
INSTALLATION Note that the installation of the FXO and FSO units are similar (1) Connecting the feed cable to the outside unit. On the mounting end of the tube there is an end cap with a weather sealing clamp. This allows the feed cable the penetrate the housing and remain sealed to outside weather. Begin with the removal of the rear end cap by using a coin as a wedge and working your way around the tube until the end cap pops off.
PAGE 14
(2) Other users of the 2.400 to 2.483 GHz ISM band. The ISM or Industrial, Scientific, and Medical band, is shared with many other type of services. Fortunately most of the users are located in urban areas, leaving sharing concerns down to consumer microwave ovens and other spread spectrum rural telephone users. The I-WLL-15 system has divided the ISM band into 8 sub-bands or channels.
PAGE 15
SYSTEM PLANNING PARTS LIST i-WLL-15 Certain requirements are necessary for the i-WLL-15 system to function. (1) A radio path with losses fitting within the capacity of the system. We have a chart showing various antenna and distance combinations . Distance Distance in Miles in km 1.5 2.4 2.0 3.2 5.0 8.0 7.0 11.3 8.0 12.9 8.0 12.9 10.0 16.1 10.0 16.1 12.0 19.3 15.0 24.1 20.0 32.2 25.0 40.2 50.0 80.
PAGE 16
Consumer and US Regulatory Information Connection to the telephone network 1. The Federal Communications Commission (FCC) has established rules which permits this device to be directly connected to the telephone network. 2. If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until repair has been made. If this is not done, the telephone company may temporarily disconnect service. 3.
PAGE 17
SCOPE OF MANUAL This manual is designed to support the installation, operation and maintenance of the i-WLL–15 All-Digital Remote Wireless Telephone Link. To avoid harm to persons or damage to the product please ensure that you have read through the unpacking and installation sections before proceeding. UNPACKING The i-WLL-15 system will arrive in one box approximately 32 x 16x 9 inches (80 x 40 x 23 cm). Small amounts of feed cable and power supplies may also be included in this box if ordered.
PAGE 18
Carlson Wireless USA Limited Warranty Carlson Wireless Telephone (CWT) or Carlson Wireless USA, Collectively referred to as "Carlson“) will repair this product with new or rebuilt parts, free of charge, in the USA or Puerto Rico for two (2) years from the date of original purchase in the event of a defect in material or workmanship.
PAGE 19
(This page is intentionally left blank.) The employees and shareholders of Carlson Wireless Telephone Inc. wish to thank you for your purchase of the i-WLL product. For more information about the company, see our web site at http://www.wirelesstelephone.com i-WLL, the i-WLL logo , Carlson Wireless USA, and the Carlson Wireless logo are registered trademarks of Carlson Wireless Telephone Inc.
PAGE 20
CARLSON WIRELESS TELEPHONE, Inc. CARLSON WIRELESS USA USA Headquarters: 1150 Evergreen Road P.O. Box 2400 Redway, CA 95560 USA Tel: +1 707 923 9593 Fax: +1 707 923 1913 Email sales@wireless-telephone.com MODEL NO. i-WLL-15 About Carlson Wireless Telephone Inc. Carlson Wireless Telephone, Inc. was formed in March 1999 as a privately held corporation based in Redway, California.