User's Manual

Remote controller
GENERAL INFORMATION
This remote controller is designed to separately control your ceiling fan speed and light brightness.
There are seven buttons (1, 2, 3, OFF) to control fan speed and off.
The light dimmer button will control the light brightness dimmer and off.
The blue indicator on the transmitter will light when one of the nine buttons is pressed.
INSTRUCTION OF INSTALLATION AND OPERATION
2.INSTALLING RECEIVER IN CEILING FAN
A. Safety precautions:
WARNING: HIGH VOLTAGE! Disconnect power by
removing fuse or switching off circuit breaker.
Do not use with solid state fans.
Electrical wire must meet all local and national
electrical code requirements.
Supply for fan must be 110/120 volt, 60Hz. Maximum
fan motor watts: 40W, Maximum down light watts: 60W
led.
Otherwise power can cause serious injury or death.
B. Installing receiver in fan:
a. Remove power from the circuit.
b. Remove ceiling fan canopy from the mounting
bracket.
c. Disconnect existing wiring between ceiling fan and
Supply in electrical junction box.
d. Make connections as follows, using the wire nuts
supplied:
Use wire connecting nuts supplied with the fan
CONNECT TO
Green fan wire ....Bare supply wire
Black receiver wire(AC IN L) .... Black supply wire
White receiver wire(AC IN N) ....White supply wire
Black receiver wire(FOR MOTOR) .... Red fan wire
White receiver wire(FOR COM) ....White light wire
Blue receiver wire(FOR LIGHT) ....Blue light wire
CAUTION: Ceiling Angle Shall Not Exceed 30 Degrees,
For Mounting Controller, Model AC8
PJES1412
ACN
ACL
ANT
FAN
INPUT
OUTPUT
RECEIVER
LIGHT
COM
(FIG.3)
FROM POWER SOURCE
AC 110~120 VOLT 60Hz
3.5AMPS.
WHITE
INPUT
OUTPUT
BLACK
ANT
CANOPY
Use wire connecting nuts
supplied with the remote
WIRE NUT
R
ECEI
VER
RECEIVER
CANOPY
(FIG.4)
ANTENNA PUT AT OUTSIDE
OF CANOPY BOX CAN GET
MORE OPERATION
DISTANCE
1.SETTING THE CODES
Setting the codes on the transmitter:
a. Remove battery cover.
b. Factory setting is all on the “ON”position.If you want to change the codes setting,please use a
small screwdriver or a ball point pen to slide firmly to your choice of”ON”or”OFF”position.(Figure 1).
Keep pressing the “LEARN”key in excess of 3 seconds it becomes a LEARN status.The receiver
can remember the last codes status.Then the light on the Fan will flash two times.
The Learn Key must be pressed within 30 seconds, after pressing the Power button.
If not, please press the Power button to restart.
ON
DIM
SWITCH
LEARN
LIGHT
ON
DIM
LIGHT
SWITC H
LEARN
If other fans or supply wires are different color,
have this unit installed by qualified licensed electrician.
e. Push all connected wires up into junction box.
f. Lay the brown antenna wire on top of the receiver,
and put the receiver into the mounting bracket.
g. Reinstall the canopy on the mounting bracket.
h. Restore power.