Installation Instructions

DC POWER CEILING FAN REMOTE CONTROL MANUAL

□INSTALLATION INSTRUCTIONS

TE:

This unit is to be used for the control of DC power ceiling fan and in an AC120V 60Hz power

suppl

y only. Output Power: 50W (Max.) for motor and 30W (Max.) for LED light.

Important: Using a full range dimmer switch (not included) to control fan speed will damage the fan.

To reduce the risk of fire or electrical shock, do not use a full range dimmer switch to control fan speed.

1. Switch power off at fuse box or circuit breaker before you begin installing the fan.

ake wiring connections as indicated Fig. 1.

Launch distance for remote control: about 10m.

he remote code setting process:

Ste

p: 1 Open the remote battery cover and install DC1.5V/AAA 2pcs

alkaline battery, with the fan power off. (Fig. 2)

Step: 2. Within 30 seconds of restring power to the fan, you must use

a ball pen or tool to press “Learn” button about 2 seconds. Once the

receiver has detected the frequency, the receiver will make sound, Bi

once. This will indicate the receiver has learned the frequency that

was previously selected on the transmitter.

FIG. 2

Note: After the AC power is on, do not press any other button on the

transmitter before setting learning. Doing so will cause the procedure

to fail.

After completing the steps above, you should be able to operate the

ceiling fan and light. If the fan is not responding to the transmitter,

please turn the power off to the receiver. And repeat step 2.

Fig. 1

g. 2

PAGE 1
DC POWER CEILING FAN REMOTE CONTROL MANUAL □INSTALLATION INSTRUCTIONS NOTE: This unit is to be used for the control of DC power ceiling fan and in an AC120V 60Hz power supply only. Output Power: 50W (Max.) for motor and 30W (Max.) for LED light. Important: Using a full range dimmer switch (not included) to control fan speed will damage the fan. To reduce the risk of fire or electrical shock, do not use a full range dimmer switch to control fan speed. Fig. 1 1.
PAGE 2
LIGHT FUNCTION SELECT SWITCH If installed energy light onto ceiling fan, please slide the dip switch, light function select switch, to “O” position. If installed dimmable LED light onto ceiling fan, please slide the “light function select switch” to “D” position. (Fig. 2) □FUCNCTIONS OF REMOTE CONTROL: (Fig. 3) Turn off the ceiling fan. Fan speed: Press and release immediately to turn on and set fan speed.
PAGE 3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.