User Manual

ManualsBrandsCaretaker Systems ManualsElectronics3-204-35

INSTALLATION AND

ALIGNMENT

Select from the following CONFIGURATIONS and

follow the appropriate instructions:

CONFIGURATION 1: FIRST ITEM IN THE BEAM

PATH IS A POST MOUNTED MIRROR OR

REFLECTOR

NOTE: THE MOUNTING POSTS HAVE NOT BEEN

PERMANENTLY ATTACHED AT THIS POINT.

1. At the Transceiver, while holding the laser mount

to prevent it from turning, loosen the Union

under the laser mount by rotating it clockwise as

viewed from above. Aim the laser until it is

hitting the Mirror/Reflector Mounting Post at the

desired height. The beam will be readily seen

as a bright red spot on the Mounting Post.

2. Tighten the Union, making sure you have not

moved the laser.

ATTACH A SWIVEL MOUNT TO EACH POST

1. Slide a Swivel Mount downward over the

Mounting Post until the Laser Spot appears in

the center of the face of the Swivel Mount as

shown at the right.

ALIGN THE SWIVEL MOUNT HORIZONTALLY

Rotate the Swivel Mount to the left or right while

viewing the Mounting Post from above.

3a. If a MIRROR is to be mounted onto the Swivel

Mount, rotate the Mount so that it faces a point

approximately half way between the Transceiver

and the selected location for the Reflector. The

Laser Spot should be in the middle of the face of

the Swivel Mount. (See Illustration 3a.)

Laser

Beam

Pth

Temporary

Fill

Beam Path

From

Beam Path From

Mirror To

Mirro

3a.

Beam Path

Laser

Swivel Mount

Screw

Summary of content (3 pages)

PAGE 1
INSTALLATION AND ALIGNMENT Select from the following CONFIGURATIONS and follow the appropriate instructions: CONFIGURATION 1: FIRST ITEM IN THE BEAM PATH IS A POST MOUNTED MIRROR OR REFLECTOR 7A NOTE: THE MOUNTING POSTS HAVE NOT BEEN PERMANENTLY ATTACHED AT THIS POINT. 1. 2. At the Transceiver, while holding the laser mount to prevent it from turning, loosen the Union under the laser mount by rotating it clockwise as viewed from above.
PAGE 2
3b. If a REFLECTOR is be mounted onto the Swivel Mount, the face of the Mount should be perpendicular to the beam path. The Laser Spot should be in the middle of the face of the Swivel Mount. (See Illustration 3b.) Reflect Beam Path From 3b. LOCK THE SWIVEL MOUNT TO THE POST 4. While holding the Swivel Mount to prevent it from turning on the Mounting Post, tighten the Phillips head screw on the back of the Swivel Mount.
PAGE 3
4b. If screws are to be used to attach the Swivel Mount to a wall or other surface, follow the procedures described on page 11. 5. 8 8A If both laser beams are being used, repeat these procedures for the second Beam Path. ATTACH THE MIRRORS AND REFLECTORS NOTE - A REMINDER: The Mounting Posts have not been permanently attached at this point. Try to keep the Posts from moving while attaching the Mirrors or Reflectors. 1.