TYPICAL Single Beam, “L” Shaped System with Transceiver at One End Reflect Existing Any Pool Mirro Beam House Door to Y d Dual Beam, “L” Shaped System with Transceiver at the Corner Reflector Gat Reflector Beam Beam House Single Beam, Straight Line System with Transceiver at One End Door to d Beam House Gat Reflect Door to Y d Gat
INSTALLATIONS Beam Reflector Beam Reflector House Door to Y d Gat Dual Beam, Straight Line System with Transceiver in the Middle Dual Beam, Three Sided System with Transceiver at a Corner Reflector Reflector “B” Existing F Beam Beam Mirro Door to Y d Hous
INSTALLATIONS Reflector Reflector Mirr Beam Beam Mirror Hous Door to Y d Dual Beam, Four-Sided System Important Points: • The beam path of every system must start at the Transceiver and end at a Reflector. • A Mirror is used to change direction of a beam path, such as going around a corner. A Mirror can be installed in a beam path only between the Transceiver and a Reflector. • The maximum length of a beam path from the Transceiver to each Reflector is 150 feet (45 meters).
INSTALLATION BEAM PATHS AWAY FROM THE POOL EDGE ARE BEST By Installing the Prevent system with the beam paths as far away from the pool edge as possible, the alarm will sound when the intruder is farther away from the pool. In the case of a very small child, this could mean that an adult, upon hearing the alarm, could get to the child before the child ever reached the water.