Safety Manual
Carestream Health, Inc. 150 Verona Street Rochester, New York 14608 © Carestream Health, Inc., 2011 Pub No. 9G3888_en Rev.
Table of Contents Safety and Related Information Safety, Warnings, and Cautions ................................................................................................. 1-1 Safety Labels ......................................................................................................................... 1-4 Safety and Health Compliance ................................................................................................... 1-8 Safety...................................................
Safety and Related Information Safety, Warnings, and Cautions Please read and understand all instructions before using this product. RISK OF ELECTRIC SHOCK: This equipment is operated with hazardous voltage which can shock, burn, or cause death. • Remove wall plug before servicing equipment. Never pull on cord to remove from outlet. Grasp plug and pull to disconnect. Do not attempt to service or repair the laser imager yourself to avoid exposure to dangerous voltage, laser beam, or other danger.
Safety and Related Information CAUTION: Do not use a microwave oven within 4 m of a laser imager. Electromagnetic radiation from a microwave oven is only an issue if after the oven door is closed and latched, the seal does not maintain an electromagnetic tight fit between the oven door and oven main housing. Determining if the seal has an electromagnetic tight fit requires special detection equipment. CAUTION: Do not use in the presence of flammable anesthetics, oxygen, or nitrous oxide.
Safety and Related Information CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CAUTION: Do not use isopropyl alcohol to clean the exterior surfaces of the laser imager. CAUTION: In the U.S., exhausted filters are considered to be non-hazardous waste according to the US Environmental Protection Agency Resource Conservation Recovery Act (RCRA).
Safety and Related Information Safety Labels Safety labels are attached to the laser imager in compliance with international standards. English Text on Labels Some names on the labels are shortened and left in English.
Safety and Related Information Labels DryView Laser Imager DryView 6800 68000501 7F2301 6551576 August 2007, 2007 08 100/120/200/220/240V 12/12/7/7/7A 50/60Hz 311346 3JZT Carestream Health, Inc. Rochester, NY 14608 TM: DryView 7F3118.E This label shows the serial number and model number of the laser imager along with other important data items. (The label shown above is an example serial plate label.) Laser Radiation Warning Labels 1 Class 3B invisible laser radiation.
Safety and Related Information Laser Imager Back Panel 1 2 3 3 4 5 6 Agency Statements 6 1 Product Label. This label states that the imager is a Laser Imaging Printer. 2 Agency Symbols and Class 1 Laser Safety. High voltage. Indicates that high voltage is present under panels where the label is attached. Only an Authorized Service Provider should attempt access. Static Sensitive Equipment. Identifies static-sensitive components.
Safety and Related Information Hot Surface Labels This label indicates that you must use care where the label is installed to avoid possible burns.
Safety and Related Information Safety and Health Compliance This equipment has been tested for and complies with the following Safety and Emissions Standards. Certificates of Compliance and Declarations of Conformity have been issued as shown below. Safety United States FDA 21CFR 807 Subpart E - Premarket Notification Procedures. 21 CFR 1040.
Safety and Related Information EMC United States FCC Rules and Regulations, Title 47, Part 15, Subpart B, Class A: Radio Frequency Devices: Unintentional Radiators. This equipment has been tested and been found to comply with the limits for a Class A digital device pursuant to part 15 of the FCC rules. Those limits are designed to provide reasonable protection against harmful interference in a residential installation.
Safety and Related Information Europe and the Rest of World Guidance and Manufacturer’s Declaration for Electromagnetic Emissions The Laser Imaging System is intended for use in the electromagnetic environment specified below. The customer or user of the Laser Imager should ensure that it is used in such an environment. Emissions Test Compliance Electromagnetic Environment - Guidance RF emissions: Group 1 The Laser Imager uses RF energy only for its internal function.
Safety and Related Information Guidance and Manufacturer’s Declaration for Electromagnetic Immunity The Laser Imager is intended for use in the electromagnetic environment specified below. The customer or user of the Laser Imager should ensure that it is used in such an environment.
Safety and Related Information Guidance and Manufacturer’s Declaration for Electromagnetic Immunity The Laser Imager is intended for use in the electromagnetic environment specified below. The customer or user of the Laser Imager should ensure that it is used in such an environment.
Safety and Related Information Guidance and Manufacturer’s Declaration for Electromagnetic Immunity Note 1 Field strengths from fixed transmitters, such as base station for radio (cellular/cordless) telephones and land mobile radios, amateur radio, AM and FM radio broadcast, and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered.
Safety and Related Information EU Directives 93/42/EEC Title: Council Directive Concerning Medical Devices. 1999/5/CE Title: Council Directive Concerning Radio Equipment and Telecommunications Terminal Equipment. Recycling Label In the European Union, this symbol indicates that when the last user wishes to discard this product, it must be sent to the appropriate facilities for recovery and recycling. Contact your local authorized representative for additional information.
Safety and Related Information Please Note The information contained herein is based on the experience and knowledge relating to the subject matter gained by the manufacturer prior to publication. No patent license is granted by this information. The manufacturer reserves the right to change this information without notice and makes no warranty, express or implied, with respect to this information.