User's Manual

7
5. INTERCOM
The SRC-System™ allows Bike-to-Bike and Rider-to-Passenger full-
duplex intercom communication at a range of up to 500m.
To chat via Intercom, you must rst pair your SRC-System™ to the
second device. Pairing is a one-time process. Once paired, the
two units will automatically recognize each other whenever in
range.
5.1 INTERCOM COMPATIBILITY
Your SRC-System™ is compatible with all Schuberth SRC-Systems™.
In addition, it is also compatible with the scala rider line of
intercom models. Range is limited to the distance of the device
with the shorter range.
For details of which scala rider models are compatible, and how
to pair and use your SRC-System™ with other models, please visit
www.cardosystems.com/SRC.
5.2 PAIRING THE INTERCOM CHANNEL
Pairing will replace any existing paired device with the new device.
If you have purchased the SRC-System™ DUO, the retail package
contains two pre-paired units.
If for any reason you have to pair them again, OR if you wish to pair
another unit, proceed as follows:
1. Check both units are in Standby.
2. On the SRC-System™, press for 5 seconds. The LED will begin
ashing RED and the unit will now enter intercom pairing mode.
3. Enter intercom pairing mode on the second unit by following
the device’s user manual. Both units will now be in intercom
pairing mode.
4. After a few seconds, the SRC-System™ will show a solid RED
light for 2 seconds, indicating that it is paired and ready to use.
If Pairing is not completed within 2 minutes, the units will return to
Standby mode. Repeat process from Step 2.
5.3 MAKING INTERCOM CALLS
Make Intercom Call
In Standby, double tap or speak any word
loudly into the microphone to call via VOX
During Music playback, tap and a
simultaneously.
End Intercom call
Tap
Use VOX to make intercom calls using only your voice (see 4.5).
VOX Intercom calls will end automatically after 30 seconds of
silence.
VOX and AGC performance will vary based on environmental
conditions including riding speed, helmet type and ambient noise.
For improved performance, minimize the wind impact on the
microphones by closing the visor.
5.4 RECEIVING INTERCOM CALLS
• If a paired rider tries calling you via Intercom, the call will begin
almost instantly
• To receive a CTL intercom call see table in section 5.6
5.5 BUSY SIGNAL
A busy signal will be heard when attempting to establish an
Intercom call with another device that is already on a phone or
intercom call.