CARDO SYSTEMS, INC.
| INTRODUCTION | CONTENTS OF RETAIL BOX | Cardo Rider Q2™ INTRODUCTION CONTENTS OF RETAIL BOX Congratulations, and thank you for having chosen the Cardo Rider Q2 Bluetooth® Headset for bikers. This Manual will help you operate the headset, but you should first familiarize yourself with the Bluetooth® functionality of your cellular phone and/or GPS device before using the Cardo Rider Q2. Volume Up Headset Charging Jack The retail box of the Cardo Rider Q2 contains one headset unit.
CONTENTS OF RETAIL BOX | BEFORE USING | Cardo Rider Q2™ | Full Duplex Intercom Connection Allen Wrench English SET UP AND CONFIGURATION Wall Charger Embedded FM Radio 200 meters (600 ft.) Velcro Pads Extension Pad Cardo Rider Q2 or scala-rider Family Headset User Guide, including Warranty and Registration form Mobile Phone GPS IMPORTANT: The Cardo Rider Q2 is a water-resistant device, designed for use under moderate rain or snow conditions.
| SETUP AND CONFIGURATION | Cardo Rider Q2™ PRIMARY BUDDY PAIRING (requires two Cardo Rider Q2 headsets) A. Both Rider and Passenger are using Cardo Rider Q2 headsets. To Pair the two headsets, follow the Steps listed in the section above titled PRIMARY BUDDY PAIRING. B. The Rider is using a Cardo Rider Q2 and the Passenger is using a scala-rider headset (i.e. a scala-rider, a scala-rider FM or a scalarider TeamSet Driver unit headset). To Pair the two headsets: 1.
SETUP AND CONFIGURATION | Cardo Rider Q2™ | SET UP FOR MOBILE PHONE CALLS: PAIRING With some mobile phones, you may need to tap the CTRL button to connect the headset to the phone after pairing is complete. The Cardo Rider Q2 headset will automatically connect to the last phone connected to the headset. If you have a Bluetooth® enabled mobile phone and would like to make and receive phone calls using the Cardo Rider Q2, you must first pair your headset to the mobile phone.
| SETUP AND CONFIGURATION | Cardo Rider Q2™ REMOVING: mobile phone to your GPS device by following your GPS and/or mobile phone’s instructions. NOTE: If the Pairing process is not completed within two minutes the headset will return to Standby mode. Your headset can be removed for charging and storage by pressing your finger gently against the tab and sliding the headset up with the other hand. We recommend that you remove the headset from the helmet when not in use.
SETUP AND CONFIGURATION | Cardo Rider Q2™ | AUDIO SOURCES AND PRIORITIES USING THE INTERCOM Receiving Intercom calls Making Intercom calls If you are not speaking with any one, once the other party tries to initiate a Buddy Intercom call, the call will begin immediately. The different Audio Sources that are connected to the Cardo Rider Q2 are prioritized as follows: Highest 1. Mobile phone Audio / GPS device (Incoming/outgoing calls , GPS audio and navigation instructions) 2.
| SETUP AND CONFIGURATION | Cardo Rider Q2™ When the headset is on an active phone call, any Buddy Intercom call request will be rejected automatically. Once the phone call audio link drops, you can initiate and accept Buddy Intercom calls. which of the two Buddy headsets you wish to connect to when using Voice Connect Intercom. NOTE: The Primary Buddy has priority by default.
SETUP AND CONFIGURATION | SUPPORT | NOTICES Cardo Rider Q2™ | Turning the FM Radio Off While the radio is turned on, press and hold the MC button for three seconds to turn the Radio off. Switching Preset FM Radio Station SUPPORT There are six pre-set Radio stations available on your Cardo Rider Q2. While the Radio is on, tap the MC Button to cycle between saved stations. For additional information please visit our website at www.cardosystems.com FAQ: www.cardosystems.
| NOTICES | Cardo Rider Q2™ Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Use only approved batteries and chargers. This equipment has been tested and found to comply with Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
NOTICES | Cardo Rider Q2™ | LIMITATION ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, AND NON-INFRINGEMENT. THE DEVICE AND ITS ACCESSORIES ARE PROVIDED “AS IS” AND “AS AVAILABLE” WITHOUT WARRANTY OF ANY KIND BEYOND THOSE ASSUMED IN THE ENCLOSED MANUAL. 1.
| Cardo Rider Q2™ | NOTICES 12