User's Manual

ManualsBrandsCardo Systems ManualsElectronicsHandsfree Adapter

CARDO BTA II

Table of Contents

Contents of the Retail package:

•BTA II

•Travel charger

•Pop-Port

connector for Nokia phones

•Velcro pad

•This Quick Start Guide

NOTE: Quick Start Guides in other languages can be

downloaded from our website.

•Stylus for SET pinhole

Warranty and Registration card

• Double side scotch tape

Product Specifications:

Typical Talk talk time: Up to 9 hours

Typical Standby standby time: In excess of

1one week

Typical charging time: 3 hours

Answer/End calls and Voice Dialing from the

headset (if supported by phone)

Bluetooth Version: 1.2

Weight: 14.4 g

Certificates: FCC, IC, CE, Bluetooth

Velcro pad

Pop-Port connector for

Nokia phones

Double side

scotch type

Stylus for SET

pinhole

Summary of content (9 pages)

PAGE 1
CARDO BTA II CARDO BTA II Table of Contents Contents of the Retail package: •BTA II •Travel charger •Pop-PortTM connector for Nokia phones •Velcro pad •This Quick Start Guide NOTE: Quick Start Guides in other languages can be downloaded from our website.
PAGE 2
Introduction Congratulations and thank you for purchasing the Cardo Bluetooth Adapter II. We hope that you will enjoy the device and remain at your service for any query or problem you may have. The BTA II – the smallest of its kind - turns your standard mobile phone into a Bluetooth powerhouse, allowing you to enjoy the hands-free benefits and advantages of your Bluetooth headset. The Cardo BTA II is compatible with virtually every standard mobile phone and works best with the Cardo Bluetooth headsets.
PAGE 3
Contents of the Retail package: • • • • • BTA II Travel charger Pop-PortTM connector for Nokia phones Velcro pad This Quick Start Guide NOTE: Quick Start Guides in other languages can be downloaded from our website. • Stylus for SET pinhole • Warranty and Registration card • Double sided scotch® tape Pop-Port connector for Nokia phones Getting Started with the Cardo BTA II 1. Charging your adapter NOTE: You must fully charge the BTA II prior to initial use! 1.
PAGE 4
. Wait a few seconds until the blue LED on the BTA II begins flashing every three seconds. 4. Placing calls Congratulations! You have now paired your headset and BTA II and are ready to begin using them! USING YOUR PHONE’S KEYPAD: Using the Cardo BTA II 1. Dial the number you wish to call on your phone’s keypad and press SEND/TALK on your phone. Before you beginAs a first step, connect the Audio cable of the BTA II to your mobile phone’s 2.5 mm headset jack. If your phone does not have a standard 2.
PAGE 5
Advanced Features 6. Enhancing Functionality of the BTA II Enhancement # 1 - AUTO-CONFIGURATION It is recommended that you auto-configure your BTA II for use with your mobile phone, as it is very likely to improve the performance of the BTA II. Auto-configuring your BTA II could provide you with the following benefits: −• Up to 40% extended battery life of the BTA II −• Added support for Answer/End/Voice Dial using the headset’s Answer/End button.
PAGE 6
Enhancement # 2 - GAIN CONTROL The BTA II comes equipped with a Gain Control feature that allows you to increase the volume heard by the party you are calling. NOTE: Turning On Gain Control may also result in an echo being heard. If this occurs, turn Off Gain Control to fix this problem. Troubleshooting and Reference 8. Troubleshooting your BTA II 1.
PAGE 7
A. Please refer to Section 6: Enhancing Functionality of the BTA II for instructions on how to enable this feature (subject to the phone’s capabilities.) B. If after performing the auto-configuration you are still unable to answer/end calls or Voice Dial via the headset, your phone does not support this feature and you must always use your phone’s keypad to answer/end calls. 4. PROBLEM: can be merged with Problem 3 I am not able to Voice Dial calls using the headset’s Answer/End button. ACTIONSOLUTION: A.
PAGE 8
B. If Gain Control is turned ON, an echo may be heard by the party you are speaking to. C. Please refer to Section 6: Enhancing Functionality of the BTA II for instructions on how to turn OFF Gain Control. 9. PROBLEM: When I receive a call, my phone rings but my headset doesn’t. ACTIONSOLUTION: A. When receiving a call, some phones do not transmit their ringtone to the headset. B. Answer the call normally as specified in Section 5: Receiving or ending calls. 9.
PAGE 9
10. Product Specifications: Typical talk time: Up6 to 10 hours (subject to your phone's particular attributes capabilities and performing implementation of the AutoConfiguration procedure) *Auto-Configuration is highly recommended. it increases battery performance for many phones. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.