INTELLIDASH+ DU900 MOUNT IT! caranddriverdashcams.com support@CDDashcams.
ENGLISH Parts Shock Absorbing Gel Strip INTELLIDASH+ Mount 3M Adhesive Disk Step 1: Install Mount As seen in the figure below, align the four hooks on the mount with the four slots on the INTELLIDASH+, and slide the mount in.
Push and slide the hooks up until you hear a click. Before After Step 2: Mount the INTELLIDASH+ As seen in the figure below, you can mount the INTELLIDASH+ onto either the dashboard or windshield of your car. When mounting on the dashboard, you may find the surface of the dashboard is uneven. If so, use the supplied 3M adhesive disk. Suction cup Adhesive disk Tear off the red 3M sticker, then stick this side to the dashboard. Press to attach the other side to the suction cup of the mount.
Press the Suction Cup down onto your car’s dashboard or windshield, and push the lock down to secure it in place. 1 2 3 Lock Step 3: Position the INTELLIDASH+ Turn this knob to adjust the mount to your desired angle. Turn this knob to adjust the mount to your desired length. Turn this knob to adjust the INTELLIDASH+ to your desired viewing angle.
Step 4: Using the Shock Absorbing Gel Strip If your INTELLIDASH+ is rattling and/or coming into contact with your dashboard, use the Shock Absorbing Gel Strip to protect your INTELLIDASH+ and dashboard. Just remove the plastic film from both sides, and place it on the bottom of your INTELLIDASH+, or on the dashboard directly below it.
ESPAÑOL Partes Tira de gel absorbente de golpes INTELLIDASH+ Montar Disco adhesivo 3M Paso 1: Instale el soporte Como se ve en la figura siguiente, alinee los cuatro ganchos del soporte con las cuatro ranuras del INTELLIDASH+ y deslice el soporte hacia adentro.
Empuje y deslice los ganchos hacia arriba hasta que escuche un clic. Antes Después Paso 2: Monte el INTELLIDASH+ Como se ve en la figura siguiente, puede montar el INTELLIDASH+ en el tablero o en el parabrisas de su automóvil. Al montarlo en el tablero, es posible que la superficie del tablero sea irregular. Si es así, utilice el disco adhesivo 3M suministrado. Ventosa Disco adhesivo Quite la pegatina roja de 3M, luego pegue este lado al tablero. Presione para unir el otro lado a la ventosa del soporte.
Presione la ventosa contra el tablero o el parabrisas de su automóvil y presione el seguro hacia abajo para asegurarlo en su lugar. 1 2 3 Cerrar con llave Paso 3: Coloque el INTELLIDASH+ Gire esta perilla para ajustar el soporte al ángulo deseado. Gire esta perilla para ajustar el soporte a la longitud deseada. Gire esta perilla para ajustar la INTELLIDASH+ al ángulo de visión deseado.
Paso 4: Uso de la tira de gel absorbente de impactos Si su INTELLIDASH+ hace ruido y / o entra en contacto con su tablero, use la tira de gel absorbente de impactos para proteger su INTELLIDASH+ y el tablero. Simplemente retire la película plástica de ambos lados y colóquela en la parte inferior de su INTELLIDASH+ o en el tablero directamente debajo de él.