User's Manual

1
RAM3G OPERATING Instructions
Your RAM3G is a very powerful device that can track, monitor and provide remote control from any cellular phone. In order
to make it as accessible and as simple to use as possible, we have provisioned RAM3G at the factory to perform the more
common functions "out of the box". It has many capabilities that we do not mention here, so contact us for any special
requirements. First follow the separately provided instructions for the installation of the RAM3G into your craft.
Loading SIMCARD
I
f your RAM3G did not ship with a SIMCARD . NOTE: YOU MUST disconnect all external power supply connections when
changing SIMCARD.
Remove screws.
Make sure the Battery is disconnected.
Locate the SIMCARD holder. Gently push the silver slide toward main holder body to release. Swivel
SIMCARD carrier up.
Insert an activated SIMCARD with the golden contact side facing downwards and the cut corner facing up as
shown.
Hinge carrier closed. Slide silver slide back away from main body to lock.
Next, take the small white plug from standby battery and slide it into the power socket.
This only goes in one way. Do NOT force.
You are now ready to load the phone numbers. Test with just one cellphone first, then load others later as
required.
Set up your phone to send a text message (SMS) TO the phone number issued with the SIMCARD
that
you just loaded into RAM3G. The SIMCARD phone number will have been issued along with the SIM card
by the network provider. The first message you must send RAM3G is your cell phone number
. Send the
following text message::
ADDPHONEn<>88888888<>+(country code)(area code)(your cellphone number) (n is ph 1 to ph 4.)
eg : ADDPHONE3 88888888 [phone] (This is loaded as ph # 3)
Spaces are indicated by <>. Don’t insert any spaces in the phone number itself. The eight 8's are a factory
password that you should change later.
Now send this off RAM3G should respond with a confirmation message. If no response is received within
about 3 minutes, it means it either did not receive the message or there was a syntax error in the command.
If this worked, you can close the unit up again carefully.
ADDING PHONE NUMBERS
You can store up to four phone numbers. Add them using
ADDPHONEn<>PASSWORD<>+(country code)(area code)(your cellphone number)
eg : ADDPHONE3 88888888 [phone] (this is loaded as Ph. # 3)