User's Manual

80
12.1.1.1 DNS
If you have a DNS with multicast DNS protocol enabled, you can access the NBX by its name “nbx-<serial-number>”, e.g.,
nbx-30AEA4AD0488.
The NBX name can be obtain from the DNS server, or by concatenating the “nbx-“ with the serial number found on the
sticker.
Enter the unit name to a chrome browser to access the unit login page.
12.1.2 Wi-Fi interface
By default, the unit arrives from the factory with Wi-Fi in “Access Point Auto off” mode in which the AP is enabled for 15
minutes each time the unit is powered-on or rebooted, to allow the user an “on-the-fly” connection, to be able to
modify the unit settings. Unless the mode is changed each time the unit is powered-on or rebooted the 15 minutes time-
out will be available. To obtain a quick connection:
1. Make sure you LAPTOP / mobile phone Wi-Fi interface is enabled.
2. Obtain the unit serial-number from the sticker.
3. Scan the Wi-Fi APs and locate the one with SSID corresponding to the serial-number.
4. Connect to the unit SSID.
5. Use the connection properties to get the unit AP IP address (usually 192.168.30.2).
6. default password is: 12345678
7. Open a chrome browser and enter the IP to access the GUI login page, or open SSH terminal with these IP.
8. To keep the Wi-Fi AP constant enter the SYSTEM-CONFIG > Wi-Fi page and change the mode to Access Point.