User's Manual
68
7 Monitor & Configuration– CLI
This section will describe some BASIC CLI access mode. A more detailed reference manual can be used.
7.1 General - CLI
After identifying the NBX R1000-RF IP Address, it can be access via SSH using standard tools, e.g. putty).
After login, there are 3 main functionalities:
• Debug – special debug instructions {internal use}
• Enable – Configure various setting in the device.
• Show – display current status of the device
In addition, there are global CLI commands:
• ? – display help (at any stage of the CLI – even during command entry)
• Exit – exit one level up
• Help – display help
• History – display current session CLI history
• Logout – Logout from the CLI session
• Top – Return to default mode
! Comments
debug Change to the debug mode
enable Turn on privileged commands
exit Exit from the CLI
help Display an overview of the CLI syntax
history Display the current session's command line history
logout Logout of the current CLI session
show Change to the show mode
top Return to the default mode
Menu commands are indicated by (M). At each hierarchy the current location is in the command prefix.
e.g. in the enable menu :
#
? →
…
configure (M)Enter configuration mode
…
in the sub menu enable>config>system>general
(config-system-general)#