Assembling & Installation Instructions

ManualsBrandsCanora Grey ManualsLightingMamie 3-Light Lantern Head

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker and remove old fixture,

including the single bar.

2. Carefully unpack your new fixture and lay out all the parts on a clear

area. Take care not to lose any small parts necessary for installation.

3. NOTE: Discharge of the finial(A), remove the plastic shim(B) and

cover(C).

4. Put the candle sleeve(E) over the lamp holder.

5. Install the light bulbs(No Included) in accordance with the fixture's

specifications. NOTE: DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

6. Attach the cover(C) and plastic shim(B) to the top pipe thread of

lamp body(D), then lock it securely with the finial(A).

7. Attach the assembly lamp body onto the post (No included) and lock

it securely with the screws(F).

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from

the fixture to the black house (hot) Wire. Connect the white wire from

the fixture to the white (neutral) house wire. Make sure all wire nuts

are secured. You may wrap the connections with electrical tape. If

your outlet box has a ground wires (green or bare copper) connect

fixture’s ground wire to it. Otherwise attach the bare copper fixture

wire to the green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the post.

Your installation is now complete. Return power to the junction

box and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

FIG.1

Or visit us on-line

Thank you for purchasing this product.

Need assistance with parts or assembly? Please call customer service

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS FIG.1 The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker and remove old fixture, including the single bar. 2. Carefully unpack your new fixture and lay out all the parts on a clear area.