PIXMA MG3200 Setup Guide © CANON INC.
Setup Guide This guide provides information for setting up a network connection for the printer.
Network Connection Wireless Connection a Preparation for Connection Before Starting Wireless Connection Setup 1. Make sure that the printer is turned on. If the power is on, the LED (Light Emitting Diode) is lit as shown in the illustration below. Notes on Wireless Connection • Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your printer to.
c Connection Using WPS 1. Press the Fit to Page button (A). 2. Make sure that the LED flashes as shown in the illustration above, then press and hold the WPS button on the access point within 2 minutes. For details on pressing the WPS button, refer to the access point manual. The (blue) Wi-Fi lamp on the printer flashes while searching for or connecting to the access point. 3.
Troubleshooting WPS E>2>1 The error appears when wireless connection setup was not completed within 2 minutes after pressing the WPS button. • Is the network device (router, etc.) turned on? If the network device is already turned on, turn it off, then turn it back on. E>2>3 The screen appears when multiple access points are detected. Wait for a while, then configure WPS settings again. Press the WPS button on only one access point. E>2>4 The screen appears when an error occurs.
