<< Previous Next >> Installing Your Multifunction to Your Network for the First Time PIXMA MX712 Mac and Windows OS 1
<< Previous Next >> Installing Your Multifunction to Your Network for the First Time PIXMA MX712 Macintosh and Windows OS Preparing to Connect My Multifunction to My Network Network Requirements Notes on Wireless Connection Installing the Drivers & Software 3 3 4 5 2
Preparing to Connect My Multifunction To My Network << Previous Next >> Network Requirements Before connecting the machine to the network, make sure that configuration of the computer and access point or router is complete, and that the computer is connected to the network. Wireless Connection Before connecting the machine to the network, the computer needs to be connected to the network. Make sure that configuration of the computer and access point or router is complete.
Preparing to Connect My Multifunction To My Network << Previous Next >> An "Ad-hoc connection," which establishes a direct connection to the computer over a wireless connection without using an access point, is not supported. Notes on Network Connection • The configuration, router functions, setup procedures and security settings of the network device vary depending on your system environment. For details, refer to your device's instruction manual or contact its manufacturer.
Installing the Drivers & Software << Previous Next >> Software Installation To use the machine by connecting it to a computer, software including the drivers needs to be copied (installed) to the computer's hard disk. The installation process takes about 20 minutes. (The installation time varies depending on the computer environment or the number of application software to be installed.) IMPORTANT • Log on as the administrator (or a member of the Administrators group).
Installing the Drivers & Software << Previous Next >> Installing the PIXMA MX712 on Your Wireless Network If you are installing your printer on your network for the first time, a step-by-step walk through of the wireless setup is built in to the installation routine of the software that shipped with your PIXMA. Simply insert the Setup CD-ROM that came with your printer into your CD-ROM drive and proceed through the easy to follow instructions. You’ll be printing wirelessly in no time.
Installing the Drivers & Software << Previous Installing the PIXMA MX712 on Your Wireless Network If you can’t find your CD-ROM, you may download the MX710 series Mini Master Setup, which includes the same step-by-step installation as the CD-ROM, by following the instructions below: 1. 2. 3. 4. 5. 6. Click here to access the MX712 Drivers & Software page. Select the operating system and version of your computer (see example below). Expand the ‘Drivers’ section, if necessary, by clicking the red triangle.
