EF-S18-135mm f/3.5-5.
Thank you for purchasing a Canon product. The Canon EF-S18-135mm f/3.5-5.6 IS STM lens is a high-performance highmagnification zoom lens equipped with an Image Stabilizer, and has been developed for digital SLRs compatible with EF-S lenses*.
Safety Precautions Handling Cautions ●● If the lens is taken from a cold environment into a warm one, condensation may develop on the lens surface and internal parts. To prevent condensation in this case, first put the lens into an airtight plastic bag before taking it from a cold to warm environment. Then take out the lens after it has warmed gradually. Do the same when taking the lens from a warm environment into a cold one. ●● Do not leave the lens in excessive heat such as in a car in direct sunlight.
Safety Precautions This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changes or modifications should be made, you could be required to stop operation of the equipment.
Shooting Precautions The EF-S18-135mm f/3.5-5.6 IS STM utilizes a stepping motor that drives the focus lens. The motor also controls the focus lens during zooming. 1. When the camera is OFF The motor does not operate while the camera is OFF or when the camera is OFF due to the use of the auto power off function. Therefore, users must be aware of the following points. ●● Manual focus adjustments are not possible. ●● During zooming, delayed focus will occur. 2.
Nomenclature Focus mode switch (→ 6) Hood mount (→ 7) Zoom position index (→ 7) Y P O Zoom ring lock lever (→ 8) Filter Mounting Thread (→ 11) Focusing ring (→ 6) C Zoom ring (→ 7) Image stabilizer switch (→ 9) Contacts (→ 6) Lens mount index (→ 6) ●● For detailed information, reference page numbers are provided in parentheses (→ **).
1 Mounting and Detaching the Lens 2 Setting the Focus Mode See your camera’s instructions for details on mounting and detaching the lens. Y P O ●● After detaching the lens, place the lens with the rear end up to prevent the lens surface and contacts from getting scratched. ●● If the contacts get soiled, scratched, or have fingerprints on them, corrosion or faulty connections can result. The camera and lens may not operate properly.
3 Hood (sold separately) Zooming Y P O The EW-73B hood cuts out unwanted light and protects the front of the lens from rain, snow, and dust. To attach the hood, align the hood’s attachment position mark with the red dot on the front of the lens, then turn the hood as shown by the arrow until the lens’ red dot is aligned with the hood’s stop position mark. The hood can be reverse-mounted on the lens for storage. C 4 To zoom, turn the lens’ zoom ring. ●● Be sure to finish zooming before focusing.
5 Fixing the Zoom Ring The zoom ring can be fixed to keep the lens at the shortest point. This function is convenient for carrying a camera on a strap because it prevents the lens from extending. 1 Y P O Rotate the zoom ring to the widest position (18 mm). C 2 Slide the zoom ring lock lever in the direction indicated by the arrow. ●● To release the zoom ring, slide the zoom ring lock lever in the direction opposite to the arrow. The zoom ring can only be locked at maximum wide angle.
6 Image Stabilizer You can use the image stabilizer in AF or MF mode. This function provides optimal image stabilization depending on shooting conditions (such as shooting still subjects and following shots). 1 C Set the STABILIZER switch to ON. ●● The Image Stabilizer cannot compensate for a blurred shot caused by a subject that moved. ●● The Image Stabilizer may not be fully effective if you shoot from a violently shaking vehicle or other transportation.
Image Stabilizer The image stabilizer for this lens is effective for hand-held shots in the following conditions. Y P O ON ON OFF ●●In semi-darkened areas such as indoors or outdoors at night. ●●In locations where flash photography is prohibited, such as art museums and theater stages. ●●In situations where your footing is uncertain. ●●In situations where fast shutter settings cannot be used. C OFF ●●When panning subjects in motion. ■ Dynamic IS Function The EF-S18-135mm f/3.5-5.
7 Filters (sold separately) You can attach filters to the filter mounting thread on the front of the lens. ●● Only one filter may be attached. ●● If you need a polarizing filter, use the Canon Circular Polarizing Filter PL-C B (67 mm). ●● To adjust the polarizing filter, first remove the lens hood. 8 You can attach extension tube EF12 II or EF25 II for magnified shots. The shooting distance and magnification are shown below.
9 Specifications Focal Length/Aperture Lens Construction Minimum Aperture Angle of View Min. Focusing Distance Max. Magnification Field of View Filter Diameter Max. Diameter and Length Weight Hood Lens Cap Case 18-135mm f/3.5-5.6 12 groups, 16 elements f/22-36* Diagonal: 74°20′ - 11°30′, Vertical: 45°30′ - 6 °20′, Horizontal: 64°30′ - 9°30′ 0.39m/1.28 ft. 0.28x (at 135 mm/5.31 inch) Approx. 248 x 372 - 53 x 80mm/9.76 x 14.65 - 2.09 x 3.15 inch (at 0.39 m/1.28 ft.) 67mm/2.64 inch 76.6 x 96.0mm/3.02 x 3.
C CT1-8582-001 0812Ni Y P O © CANON INC.