Specification Sheet

ManualsBrandsCanon ManualsCamcorder AccessoriesCanon Speedlite EL-1 Flash

Flash

Compatible Cameras Type-A EOS cameras (E-TTL II/E-TTL autoash)

Flash Coverage

(Focal length; for 35mm

full-frame)

14mm

Wide Panel: Manual

* Not compatible with EF15mm f/2.8 Fisheye or EF8-15mm f/4L Fisheye USM shoot-

ing angles of view

24mm

Zoom

• A: Auto

Flash coverage is set automatically, accounting for [Auto zoom for sensor size] and

[Light distribution] settings at the lens focal length.

• M: Manual

Flash coverage is set manually

[Auto zoom for sensor size] and [Light distribution] settings are not taken into account.

28mm

35mm

50mm

70mm

80mm

105mm

135mm

200mm

Guide Number

• The Guide No. is approximately 46.3 ft./14m at ISO 100.

-When the extendable wide panel is pulled out, the ash coverage is 14mm.

• The maximum Guide No. is approximately 196.9 ft./60m at ISO 100 and 200mm ash

coverage.

-When the extendable wide panel is pulled out, the ash coverage is 14mm.

Maximum Energy 76 Ws.

Flash Modes

(Exposure Control Modes)

Flash Mode

Flash

Exposure

Compensation

FEB FE Lock

Wireless

Radio

Transmission

Optical

Transmission

E-TTL II/E-TTL autoash*¹ Yes Yes Yes Yes Yes

Manual Flash Yes Yes

Stroboscopic Flash Yes Yes

Auto External Flash

Metering

Yes Yes Yes*²

Manual External Flash

Metering

Continuous Shooting

Priority Mode

Yes Yes Yes

Group Firing*³ Yes Yes Yes*⁴ Yes

*1: Set automatically when the camera shooting mode is set to Basic Zone modes.

*2: Only Group ring is available.

*3: Can only be set when the Speedlite is used as a sender in radio transmission wireless operation.

*4: Only groups set to E-TTL II / E-TTL autoash.

Specications

Summary of content (8 pages)

PAGE 1
Specifications Flash Compatible Cameras Type-A EOS cameras (E-TTL II/E-TTL autoflash) Wide Panel: Manual * Not compatible with EF15mm f/2.8 Fisheye or EF8-15mm f/4L Fisheye USM shooting angles of view 14mm 24mm Zoom 28mm Flash Coverage (Focal length; for 35mm full-frame) • A: Auto 35mm Flash coverage is set automatically, accounting for [Auto zoom for sensor size] and 50mm [Light distribution] settings at the lens focal length.
PAGE 2
Flash Exposure Compensation ±3 stops, in 1/3-stop or 1/2-stop*¹ increments. * The Speedlite's flash exposure compensation takes precedence if flash exposure compensation is performed by both the Speedlite and the camera. Users who prefer to enable flash exposure compensation by the camera should set flash exposure compensation by the Speedlite to 0. *1: Corresponds to exposure level increments on the camera. FEB ±3 stops, in 1/3-stop or 1/2-stop*¹ increments.
PAGE 3
System: Infrared AF-assist beam AF Assist Beam Compatible AF System:TTL second image formation phase-difference AF Supporting 1–191 AF points (28mm or longer focal length) • Phase-difference AF during viewfinder shooting Effective Range (Approx.): At center: 2.0–32.8 ft./0.6–10.0m At periphery: 2.0–16.4 ft./0.6–5.
PAGE 4
Communication Functions Compliance standards IEEE 802.15.4, ARIB STD-T66 Communication method Primary modulation: OQPAK Secondary modulation: DS-SS Transmission frequency 2405-2475 MHz Channel Channel 1-15 Setting: Auto / Manual Wireless radio ID 0000 to 9999 Setting: Manual Transmission range*¹*² Approx. 98.4 ft. / 30 m Groups Up to 5 groups (A-E) * Sender units are set to Group A Number of possible units Up to 16 units of senders and receivers in total for communication Max.
PAGE 5
Group firing details Enables separate configuration of flash firing control conditions 1-3 below for each groups (A, B, C, D, E), to combine multiple methods of flash firing control. (1) E-TTL II / E-TTL autoflash (2) Manual flash (3) Auto external flash metering For all flash output set for groups A-E above, the same flash exposure compensation can be set.
PAGE 6
Manual Flash Details Stroboscopic Flash Details ALL Flash output setting: 1/128 to 1/1 A+B Flash output setting: 1/128 to 1/1 A+B+C Flash output setting: 1/128 to 1/1 Number of Flashes 1-40 Flash frequency 1-199 Hz ALL Flash output setting: 1/128 to 1/4 A+B Flash output setting: 1/128 to 1/4 A+B+C Flash output setting: 1/128 to 1/4 Manual flash Individual Receiver Details Stroboscopic flash Flash output setting: 1/8192 to 1/1 • Flash output setting: 1/8192 to 1/4 • Flash count: 1-100 •
PAGE 7
Functions Set in C.Fn-21 Light Distribution 0: Standard A light distribution setting that balances light distribution and the guide number. 1: Guide number priority Prioritizes illumination at the center of the screen, the periphery may be dark. 2: Light distribution priority Light distribution that reduces peripheral darkness. 14 Functions Function C.Fn-00: Distance indicator display C.Fn-01: Auto power off C.Fn-02: Modeling flash C.Fn-03: FEB auto cancel C.Fn-04: FEB sequence C.
PAGE 8
9 Functions Function Setting 0 Infrared 1 Emmitting small series of flashes 0 ON 1 OFF 0 OFF 1 ON P.Fn-04: Change settings with the direct dial 0 OFF operation 1 ON 0 OFF 1 ON 2 ON / MODE: ETTL<-> M 0 ON 1 OFF 0 ON 1 OFF P.Fn-01: AF-assist beam emission method P.Fn-02: Quick flash P.Fn-03: Flash firing during linked shooting Personal Functions Number P.Fn-05: FE memory P.Fn-06: Beep P.Fn-07: Fan Brightness: 5 levels P.Fn-08: Modeling lamp (brightness, color) P.