User’s guide «FCC » DECLARATION OF CONFORMITY FCC rules – PART 15 NUM’AXES declares that the training collar DOGTEK CANICOM 400 complies to all dispositions of the part 15 of the FCC rules This device complies with part 15 of the FCC. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including interferences that may cause undesired operation.
WARNING Any person with individual device for cardiac assistance (pacemaker, defibrillator) must take precautions when they use CANICOM 400. These devices emit some static magnetic fields (a magnet is located in the remote control) (Frequency= 915 MHz, at = 0.75 mW). The device complies with Part 15 of the FCC rules. Any technical changes or modifications on the receiver collar or on the remote control not expressly approved by the manufacturer shall void the user’s authority to operate the equipment.
● Contents of the product CANICOM 400 Inside the ▪ ▪ ▪ ▪ ▪ ▪ ▪ packaging you will find: 1 CANICOM receiver collar equipped with short contact points 1 lithium 3 Volt CR2 battery for the collar 1 CANICOM 400 remote control equipped with 1 lithium 3 Volt CR2 battery 1 neon test lamp 1 pair of long contact points 1 carry strap this user’s guide ● Description of the product 2 contact points (short or long) On/Off indicator + indicator of radio reception + battery level indicator Red mark: Area where the On
If you do not hear any beep sound after inserting the battery, immediately remove it from its housing. Check the polarity before trying again. - Before putting the lid back in place, check that the rubber seal is in its groove. Polarity “-” of the battery Polarity “+” of the battery Seal Diagram 6 Activate/deactivate the remote control Remote control is supplied with battery fitted. ▪ Activate: Press the On/Off red button ( ) located on the side of the remote control for 1 second (ref.
The coding of the remote control with the receiver collar(s) enables to couple your remote control with the receiver collar(s) provided. IMPORTANT: before beginning the coding (first use of the receiver or re-coding), make sure no other person is using his CANICOM 400 or other products from DOGTEK range close by. Your receiver could accidentally record the code of his remote control. If that occurs, re-code the remote control with the receiver collar.
It is up to you to use the beeper depending on the way you want to train your dog. With the beeper you can: - send a sound to your dog when it is disobedient, - draw its attention … It is very important to always use the beeper in the same way in order not to disturb your dog. F button: Flash stimulation Press the “F” button to send a warning to your dog using stimulations transmitted by two contact points located on the receiver collar for a defined length of time of less than one second.
Replace ▪ ▪ ▪ ▪ ▪ ▪ the battery as follows: On the back of the remote control, unscrew the screw and remove the battery cover. Remove the old battery. Insert the new battery paying attention to follow polarity indicated on the battery housing. Put the lid back in place. Put the top back, using the screw. Check the remote control operates correctly.
The training instructions you give to your dog are sent from the remote control to the receiver collar(s) by radio waves. These radio waves are sensitive and the range reaches approximately 400 yards for the CANICOM 400 (depending on geography and environment). The performances of your CANICOM 400 will be optimal if you respect the following recommendations: ▪ To obtain a good radio range, do not cover the top of the remote control unit with any part of your hand while holding.
● Cautions for use ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ Before using CANICOM 400, we advise you to have your dog checked by your vet to ensure it is fit to wear a collar. The CANICOM receiver collar is totally waterproof. Your dog can swim in water. In order to maintain water tightness, we recommend the replacement of the seal located in the receiver collar every year. The CANICOM 400 remote control is showerproof only. It is only designed to remain a short time in the rain. Put it safe from water as soon as possible.
● Technical specifications CANICOM 400 CANICOM remote control receiver collar Power 1 3-V lithium battery CR2 1 3-V lithium battery CR2 Battery life Continuous use: In stand by: approximately 7 months approximately 30 000 triggers Continuous use: approximately 2 months Frequency (Power) 915 MHz (0.
You can purchase spare parts (batteries, straps, single collar…) from DOGTEK or from your supplier at any time.