Installation Guide

Page 1

INSTALLATION GUIDE

Built-in Tumble Dryer

INSTRUCTIONS FOR MOUNTING

THE FURNITURE DOOR

ATTENTION

IMPORTANT

STEP ONE

Do not use adapters, multiple connectors &/or

extensions.

Never install the dryer against curtains & be sure to

prevent items from falling or collecting behind the

dryer.

The appliance must not be installed behind a lockable

door, a sliding door or a door with a hinge on the

opposite side to that of the tumble dryer.

During transport ensure that the dryer is in an upright

position, if it’s necessary you can only flip in the side

shown;

If the product is in different side, wait at least 4 hours

before switching on so that the oil can flow back into

the compressor. Failure to do this could result in

damage to the compressor.

Regulate the height of the dryer

The 4 adjustable feet allow the height of the dryer

to be adjusted from 827mm to a maximum of

847mm. To adjust the height, you should rotate the

adjustable feet, ensuring that the machine is level

(fig 1).

We suggest to put the dryer at the maximum height

possible in order to avoid tilting, leaving at least 5mm

from the top of the furniture.

Before fixing the hinges it’s nececcary to determine

the depth of the dryer from the front part of the

kitchen according to the depth of the kick plate

(check picuture) & chose the right installation option

(fig 2).

Option 1 the position of the plinth of the dryer is set

back less than 54mm from the front of the furniture.

CAUTION

PAGE 1
INSTALLATION GUIDE Built-in Tumble Dryer ! ATTENTION Do not use adapters, multiple connectors &/or extensions. INSTRUCTIONS FOR MOUNTING THE FURNITURE DOOR Never install the dryer against curtains & be sure to prevent items from falling or collecting behind the dryer. The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the tumble dryer.
PAGE 2
INSTALLATION GUIDE Built-in Tumble Dryer STEP THREE Fix the hinges in palce (on the door) with the 4 screws provided (A) (fig 4). Fix the magnet (B) in place using screw (C) (fig 4). Mount the plate (D) on the right or left - hand side, depending on your installation requirements (fig 5). STEP TWO Positon the template onto the reverse of the furniture door.It is possible to mount the hinges & closure magnet on the right or left-hand side depending on your requirments.
PAGE 3
INSTALLATION GUIDE Built-in Tumble Dryer STEP FIVE Pay attention to position the bottom hinge 40mm above the kick plate in order to facilitate its removal (fig 9). Now it’s possible to fix the hinges to the door of the furniture. Use the N 4 mount caps (G) to cover all the holes on the front panel of the dryer. STEP SEVEN A furniture plinth may be run across the front of the dryer,but its height will be dictated by the front kickplate Plinth must have ventilation slots (min.