Installation Guide

ManualsBrandsCandice Olson ManualsOtherCluny 4-Light Chrome Chandelier with Crystal Accents and Chocolate Shades

INSTALLATION INSTRUCTION FOR FIXTURE

7473-4H, 7474-4H, 7476-4H,6678-4H,6686-4H

WARNING! SHUT OFF THE POWER AT FUSE OR CIUCUIT BREAKER.

MOUNTING THE FIXTURE

1. Shut off the power supply at the fuse box or circuit

breaker box. Remove the old fixture from ceiling.

Including the universal mounting plate.

2. Carefully unpack your new fixture and lay out all the

parts on a clear area. Take care not to lose any small

parts necessary for installation.

3. Thread the nipple (J) into the coupling (L) tightly;

4. Assemble the tube (E) together using nipple (D) well,

then thread the bottom end of tube (E) onto the nipple

(F) and thread the top end of tube (B) into the swivel

5. Put the candle cover (I) over the socket (K), then put

the fabric shade (H) over the candle cover (I) and

Install the light bulb in accordance with fixture’s

specifications. DO NOT EXCEED THE MAXMUM

WATTAGE RATING!

6. Thread 2 mounting screws through the mounting screw

holes from the back of the universal mounting plate.

7. Attach universal mounting plate to the Outlet box using

2 Box Screws. The side of the universal mounting plate

marked “GDN” must face out.

8. Follow the wiring instructions carefully (See Fig.2).

9. Attach the fixture main body onto the out let box by

protruding 2 mounting screws through the mounting

screw holes on the fixture canopy (A), then tighten it

with 2 ball nuts (B).

Wiring (See fig.2)

1. Connect the electrical wires as follows. Connect the

black wire from the fixture to the black (HOT) house

wire. Connect the white wire from the fixture to the

white (Neutral) house wire. Make all the wire nut was

secured. You may wrap the connections with

electrical tape. If your outlet box has a ground wire

(Green or Bare Copper) connect fixture’s ground

wire to it. Other wise attach the bare copper fixture

wire to the green ground screw on the cross bar.

2. Tuck the wire connections neatly into the ceiling

junction box.

Fig.2

NIPPLE(D)

SWIVEL(C)

TUBE(E)

FIXTURE BODY(G)

NIPPLE(F)

OUTLET BOX

WIRE CONNECTORS

FIXTURE CANOPY(A)

Fig.1