Instructions / Assembly

LED OUTDOOR
LIGHTING
LOL578
09/21
Tel: [phone], Fax: [phone]
5. Once connections of
wires are completed,
carefully tuck wires and wire
nuts into the electrical box
making sure no bare wire (on
the black and white) is visible
at the wire nuts.
6. Position fixture over
studs on mounting bracket
assembly. Secure fixture in
place with star washers and
cap nuts.
7. After installation, seal
around the top and side
perimeter between the
fixture and the wall surface
with weather resistant
caulking. The bottom should
be left un-caulked to prevent
moisture build-up. Apply a
small amount of weather
resistant caulking around the
side perimeter between the
cap nut and mounting plate.
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Wiring supplies
as required by
local electrical
code
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. NOT FOR USE IN LUMINAIRES CONTROLLED BY A DIMMER.
5. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A
CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
Weather Resistant
Caulking
(not included)
INSTALLATION:
SAFETY PRECAUTIONS:
TOOLS AND MATERIALS REQUIRED:
1. Loosen “B”. Adjust stud to
desired length and lock in place
with “B”.
2. Mount the mounting
bracket to electrical box using
electrical box screws (not
included). Make sure the studs
on the mounting bracket are
facing out from the electrical
box.
3. Position mounting bracket
so that the fixture will be hung
properly once it is mounted to
the wall. Tighten the screw to
hold in place.
4. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground
screw in the electrical box.
Connect the black wire from the
fixture to the black wire in the
electrical box and connect the
white wire from the fixture to
the white wire in the electrical
box.
NOTE: Do not disconnect any
pre-wired connections.
WhiteBlack
House supply
Ground wire
Fixture
Ground wire
Studs
Screw
Studs
Electrical
Box
Electrical Box Screws
(not included)
Mounting
Bracket
“B”
Star
Washer
Stud
Cap
Nut
Cap
Nut
Fixture