User's Manual

WIRELESS MOUSE USER MANUAL
CONNECT THE MOUSE
Plug-in the mini receiver enclosed to the computer USB port,. Turn on the computer
B. Connect the mouse
1. Insert the 2*AAA batteries into the rear of the mouse. Please note that the direction of the
battery must be correct.
2. After the system finished loading, press the connect button on the receiver, then press the
connect button on the rear of the mouse.
3. Move the mouse and check if the receiver connecting light is on (green color light). If the
green light on, it means the mouse and receiver already connecting.
Please note that the above actions are only requested when you change the batteries for the
mouse. You don’t need to re-connect the mouse every time when you turn on the system.
If you didn’t use the mouse for a while (several minutes), you might need to press mouse
button or move the mouse to make them re-act.
This mouse is totally compatible with Microsoft Intelli-mouse mode. No
extra driver requested to install. After connection successfully, the mouse
work.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions.
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that
may cause undesired operation.
Per FCC 15.21, you are cautioned that changes or modifications not expressly approved
by the part responsible for compliance could void the user’s authority to operate the
equipment.