User's Manual

ALO BT Mini-Module – User’s Manual DRAFT
FCC ID: 2AS58-BT01
IC: 24976-BT01
FCC Part 15 Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes to the Device
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate the equipment.
Device Antenna
Module shall be used with supplied +3dB quarter-wave whip antenna, attachment of any higher-gain
antenna or other-patterned antenna is not permitted. Increases in the shielded length of the antenna
which do not increase its gain or change its emission pattern are permitted. Modification of the module
to install an antenna not approved for use voids the user’s authority to operate the equipment.
Co-Location
This device and its antenna must not be co-located or operated in conjunction with another transmitter
or antenna.
Digital Device Integration
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.

Summary of content (3 pages)