Selfsat TOP Satellite Flat Antenna with Lift and Rotation Unit Manual
www.camos-multimedia.com 1. Contents: Quantity 1 1 2 1 1 1 1 1 1 1 1 1 1 Description Antenna Selfsat HD 10 Lift and Rotation Unit (pre-assembled) Ceiling Support plates Ceiling plate Rotation handle Elevation handle Spring Washer Graduation disc Antenna cable 5m one side with F-series connector F-connector Protector Gel Cable entry box Screws 2.
. Installation Planning Decide where you wish to mount your satellite system. Location of the lift assembly must allow antenna to point towards the rear of the vehicle when resting in the travel position, and must clear all roof mounted equipment when being raised, lowered or rotated. The inside ceiling must be clear of obstructions to ceiling plate and handle. Before drilling, check for cables or obstructions within the roof space.
. Mounting Using a 38mm diameter hole saw, cut a hole through the roof and ceiling for the centre shaft. Apply a layer of approx. 0,5 cm thick of adhesive such as Sikaflex® on the bottom of the base plate. Follow the manufacturer’s guidelines for surface preparation, application and curing. Insert the crankshaft with square tube into the hole, then position and attach the lift assembly to the roof with the enclosed self-cutting tapping screws. Measure the thickness of the roof.
. Connecting the Antenna Connect the coaxial cable to the antenna and tighten. Feed the cable sidewise through the lift assembly, then insert cable through gland in rear of roof entry box and push cable into vehicle. Leave 70 cm of cable (see indication) from antenna to roof entry. Following glue on the cable entry box to the roof (e.g. with Sikaflex®). Route cable to satellite receiver and fit ‘F’ connector. Connect to the connector marked "SATELLITE IN" on the rear of the satellite receiver. 6.
and With the the direction turn the Indicator into this direction. The graduation disc also will be used to indicate the approximate direction position of the desired satellite. enclosed compass find out north and "N" Turn the indicator of rotation handle into the area of desired satellite, which appears highlighted in colour on the graduation disc. Turn the rotation handle slowly inside this area, until you receive the desired TV-channel. Note: Stop rotating the antenna if you notice a resistance.
. To Lower Antenna: Pull rotation handle down to disengage gear from ceiling plate and rotate the antenna until the pointer on the ceiling plate is aligned with the pointer on the rotation handle. Rotate elevation handle counter clockwise until you hear the antenna touch the roof (resistance will be felt in the handle). If you notice resistance during rotation (the antenna cable maybe winded around the unit), turn into contrary direction.
IMC GmbH (Camos Europe) Carl-Zeiss-Str. 7 22946 Trittau Tel 04154 / 8083 - 0 www.camos-multimedia.com info@camos-multimedia.