Installation Instructions

ManualsBrandsCamden Door Controls ManualsElectronicsDoor Interface Relay

Page 1 of 15

Electrified Locks, Relays and Timers

CX-12 PLUS

Door Interface Relay

INSTALLATION INSTRUCTIONS

1. GENERAL DESCRIPTION

Camden CX-12 PLUS Door Interface Relay provides all the functionality of the CX-12 and the CX-22 combined into 1 package.

In addition, a new Ratchet Relay mode is provided, making the CX-12 PLUS one of Camden's most versatile door control

relays available.

Used as a make/break relay (or Switching Network), it eliminates the binding of locked automatic doors, by delaying the door

operator until the strike or maglock de-activates rst.

2. SPECIFICATIONS

Input Voltage

12/24V AC/DC

Contact Rating

3 Amps @ 30 VDC

Current Draw

20 mA Idle | 60 mA Operating

Response Time

0.3 Seconds

Inputs

2 Wet & 2 Dry, N.O.

(3-30V AC/DC, Optically isolated,

non-polarity sensitive)

Outputs

2 x Form C (SPDT)

Electrical Life

100,000 @ Rated Capacity

Modes

Time Delay

D.0.R #1: 1-30 Seconds

D.0.0 #2: 1-30 Seconds

D.0.R #3: 1-30 Seconds

Dimension

3-1/4” W x 2-5/16” H x 11/16” D

(83mm x 59mm x 18mm)

3. OPERATION

There are 8 modes of operation, selectable by DIP switches:

DIP SWITCH

MODE DESCRIPTION

SW1 SW2 SW3

OFF OFF ON 1a & 1b Momentary & Momentary Apartment

ON OFF ON 2 Access Control (Maintained)

ON ON ON 3 Smoke Evac.

OFF ON ON 4 Latching / Ratchet Mode

OFF OFF OFF 5 Bi-Directional Sequencer - Momentary

ON OFF OFF 6 Bi-Directional Sequencer - Maintained

OFF ON OFF 7 Restroom Control - Normally Unlocked

ON ON OFF 8 Restroom Control - Normally Locked

Summary of content (15 pages)

PAGE 1
El ec trifi ed Lo ck s , Rel a y s a nd T im e r s CX-12 PLUS Door Interface Relay INSTALLATION INSTRUCTIONS 1. GENERAL DESCRIPTION Camden CX-12 PLUS Door Interface Relay provides all the functionality of the CX-12 and the CX-22 combined into 1 package. In addition, a new Ratchet Relay mode is provided, making the CX-12 PLUS one of Camden's most versatile door control relays available.
PAGE 2
CX-12 PLUS DOOR INTERFACE RELAY I N S TA LL AT I O N INS TRUCTIO NS Momentary Operation In the Momentary position, even a stuck switch input will allow the door to time out and close, thereby providing security to occupants. The CX-12 PLUS will however, still operate normally if one of the other inputs is activated. Essentially, it ignores the faulty activation source, as all inputs are isolated.
PAGE 3
CX-12 PLUS DOOR INTERFACE RELAY INSTALLAT I ON I N S TRU CTI O NS Note: Do not wire Safety devices to the CX-12. If installed, wire your safety device directly to the operator control box as per usual. IMPORTANT: Do not apply power to the unit until all secondary wiring is complete, and dip switches have been set. Both relay outputs are Form C and are rated at 3 amps maximum. Use relay # 1 for the strike or electromagnet. Generally, the N.O. & COM. Terminals (#3 & 4) are used for a strike, and COM & N.C.
PAGE 4
CX-12 PLUS DOOR INTERFACE RELAY I N S TA LL AT I O N INS TRUCTIO NS OFF / ON Washroom Door Controller 1 For Normally Unlocked Door set dip switches as shown. 2 3 Also refer to Diagram 6. For Normally Locked Door set dip switches as shown. Also refer to Diagram 7. OFF / ON 1 2 3 Connect the inputs from the various switches according to the appropriate diagram.
PAGE 5
0.71” (18mm) 0.61” (15.5mm) INS TA LL AT ION IN ST RUCT IONS 2.31” (59mm) CX-12 PLUS DOOR INTERFACE RELAY CX-12 2.96” (18mm) 3.25” (83mm) 3 3 Wet1 Input Dry1 Input Dry1 Input Wet2 Input Wet2 Input Dry2 Input Dry2 Input 10 11 12 13 14 15 16 DRAWN BY: J. LEWIS DATE: 01/13/10 FILENAME: CX-12PLUS-CAD.ai CX-12 Electrical and Mechanical SCALE: NONE Page 5 of 15 5502 Timberlea Blvd.
PAGE 6
Wire MOV (supplied) MOV directly to strike or magnet 12/24 V AC/DC Power + Power for Strike - Electric Strike NO 3 POWER 1 2 COM 4 5 NC Relay2 6 NO Relay1 7 COM 8 DOO RL2 OFF / ON DOR 2 RL2 3 Radio Receiver 3 -Term DRAWN BY: DGW DATE: 11/16/09 CAMDEN DOOR CONTROLS REVISED: 1/28/2020 5502 Timberlea Blvd. Mississauga, Ontario L4W 2T7 Dry Input (ie. Push Switch) Wet Input (ie. Radio Receiver) DRAWING No: DRG-CX-12PLUS-01 Page 6 of 15 FILENAME: CX-12PLUS-Diagram1.
PAGE 7
Wire MOV (supplied) directly to strike or magnet 12/24 V AC/DC Power MOV + Power for Strike - (If Mag lock used, wire to Terminals 4 & 5) 3 1 2 Electric Strike NO POWER 4 COM Relay1 5 NC Relay2 6 7 8 DOO RL2 DOR RL2 OFF / ON 3 2 1 DRAWN BY: DGW DATE: 11/16/09 CAMDEN DOOR CONTROLS REVISED: 1/28/2020 5502 Timberlea Blvd.
PAGE 8
Wire MOV (supplied) directly to strike or magnet 12/24 V AC/DC Power MOV + Power for Strike - (If Mag lock used, wire to Terminals 4 & 5) Electric Strike 3 1 2 4 COM Relay1 NO POWER 5 NC Relay2 6 7 8 DOO RL2 DOR RL2 3 2 1 OFF / ON DRAWN BY: DGW DATE: 11/16/09 CAMDEN DOOR CONTROLS REVISED: 1/28/2020 5502 Timberlea Blvd.
PAGE 9
Wire MOV (supplied) directly to strike or magnet 12/24 V AC/DC Power MOV 1 2 + Power for Strike - (If Mag lock used, wire to Terminals 4 & 5) 3 POWER Electric Strike NO Relay1 4 COM 5 Relay2 6 7 8 DOO RL2 DOR RL2 OFF / ON 3 2 1 DRAWN BY: DGW DATE: 11/16/09 CAMDEN DOOR CONTROLS (Optional) Vestibule Keyswitch REVISED: 1/28/2020 5502 Timberlea Blvd.
PAGE 10
Wire MOV (supplied) directly to strike or magnet 12/24 V AC/DC Power MOV + Power for Strike - (If Mag lock used, wire to Terminals 4 & 5) 3 1 2 Electric Strike NO POWER 4 COM Relay1 5 NC Relay2 6 7 8 DOO RL2 DOR RL2 OFF / ON 3 2 1 DRAWN BY: DGW DATE: 11/16/09 REVISED: 1/28/2020 5502 Timberlea Blvd.
PAGE 11
Wire MOV MOV (supplied) directly to strike or magnet 12/24 V AC/DC Power + 4 COM 5 Relay2 6 7 8 DOO RL2 DOR RL2 OFF / ON 3 2 DRAWN BY: DGW DATE: 11/16/09 Dry Input (ie. Push Switch) REVISED: 1/28/2020 5502 Timberlea Blvd. Mississauga, Ontario L4W 2T7 (ie. Radio Receiver) Wet Input CAMDEN DOOR CONTROLS Com DRAWING No: DRG-CX-12PLUS-04a Page 11 of 15 FILENAME: CX-12PLUS-Diagram4a.
PAGE 12
/24 V AC/DC Power Door #1 Operator 3 1 2 4 COM Relay1 NO POWER 5 NC Relay2 6 7 DOR RL2 3 2 1 DRAWN BY: DGW DATE: 02/08/09 CAMDEN DOOR CONTROLS Door #2 Operator REVISED: 1/28/2020 5502 Timberlea Blvd. Mississauga, Ontario L4W 2T7 (ie. RF Receiver optional) Wet Output Door Push Switch DRAWING No: DRG-CX-12PLUS-04b Page 12 of 15 FILENAME: CX-12PLUS-Diagram4b.
PAGE 13
3 2 Wet Output (ie. RF receiver optional) Door # 1 Operator 12/24 V AC/DC Power 1 2 Door #1 Push Switch 3 POWER Relay1 4 5 Relay2 6 8 DOR RL2 3 2 Door # 2 Operator REVISED: 1/28/2020 DRAWING No: DRG-CX-12PLUS-05 Page 13 of 15 FILENAME: CX-12PLUS-Diagram5.ai CX-12PLUS Bi-Directional Sequencer Wiring Diagram DATE: 02/08/09 5502 Timberlea Blvd. Mississauga, Ontario L4W 2T7 Wet Output (ie.
PAGE 14
Gray Red Gray Optional Annunciator Options OCCUPIED Camden CM-AF500 Occupied /Door Locked Signage Wire MOV (supplied) directly to strike MOV or magnet (If Fail-Secure lock is used, wire to Terminals 4 & 5) Fail-Safe Electric Strike 12/24 V AC/DC Power Harness plugs into CM-9600 Circuit board + 4 5 Power for Strike - 3 1 2 Relay1 NO POWER COM Relay2 6 7 DOR RL2 3 2 N.C.
PAGE 15
Wire MOV (supplied) directly to strike or magnet MOV (If Fail-Safe lock is used, wire to Terminals 4 & 5) Fail-Secure Electric Strike 12/24 V AC/DC Power + Power for Strike - 3 1 2 4 COM Relay1 NO POWER 5 NC Relay2 6 7 8 DOO RL2 DOR RL2 OFF / ON 3 2 1 DATE: 11/16/09 CAMDEN DOOR CONTROLS DRAWN BY: DGW Inside Wall Switch REVISED: 1/28/2020 5502 Timberlea Blvd. Mississauga, Ontario L4W 2T7 Inside ‘Push to Lock’ Switch PUSH TO LOCK N.C.