Installation Instructions

ManualsBrandsCamco Mfg ManualsElectronicsWireless remote

INSTALLATION INSTRUCTIONS ANCHOR WINCH WIRELESS REMOTE CONTROL KIT

Control Unit

(CU)

Connect Battery

Wires

Antenna Wire,

DO NOT CUT

Connect to

Switch on

Cover

Connect Motor to

Control Unit

T10116

For use with the TRAC® Anchor Winch Models: Fisherman 25® and Pontoon 35®

Push-button Anchor Winch operation from any location, in addition to the switch on the winch housing.

UNPACKING

When unpacking, ensure that all parts are present and inspect for any damage that may have occurred during transit.

KIT INCLUDES:

 Control Unit (CU)

 Handheld Wireless Remote with bracket and 2 screws

 Shrink Tube, 2 pcs

 4 Plastic Cable Ties (used for older winch models without control unit mounting plate)

INSTALLATION INSTRUCTIONS

1. Remove cover, and disconnect the switch, motor and

battery connectors. Remove existing Control Unit (CU) from winch

frame.

To disconnect the battery wires, first remove shrink tube.

Cut with a utility knife. DO NOT cut fingers! Be careful.

2. Install the Wireless Control Unit (CU) using the holes or slots that match the bolt pattern. (No drilling required.)

Install Wireless CU with existing screws from the standard CU that was removed.

NOTE: In older models without a CU mounting plate, place a cable tie through each of the four holes located on the

Wireless CU. Loop two cable-ties, loosely but evenly, around the lower bar FIRST, then loop the last two around the

upper bar and tighten all cable ties.

3. Place shrink tube over each battery wire before making the

connection. After connection is made, slide the shrink tube over

the metal connectors. Heat the shrink tube with a hot air gun, or

other heat source. The tubing will shrink down to the wires and

seal the connection.

4. Connect winch motor to the CU. Connect the switch the CU.

5. Replace cover.

Battery Wires

Control

Unit (CU)

Motor Connector

Switch

Connector

Control

Unit

Battery Wires

CU Mounting

Plate

CU Mounting

Plate

Summary of content (3 pages)

PAGE 1
® INSTALLATION INSTRUCTIONS ANCHOR WINCH WIRELESS REMOTE CONTROL KIT T10116 For use with the TRAC® Anchor Winch Models: Fisherman 25® and Pontoon 35® Push-button Anchor Winch operation from any location, in addition to the switch on the winch housing. UNPACKING When unpacking, ensure that all parts are present and inspect for any damage that may have occurred during transit.
PAGE 2
® INSTALLATION INSTRUCTIONS ANCHOR WINCH WIRELESS REMOTE CONTROL KIT RE-PROGRAMMING INSTRUCTIONS NOTE: The remote is pre-programmed to the CU at the factory and does not need to be programmed when purchased. These instructions are for future reference should you need them. 1. Press ON and DOWN on the remote within 2 seconds after connecting the winch to the battery. 2. Hold 5 seconds then release ON and DOWN buttons. 3. Re-programming is done.
PAGE 3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.