CP1/CP2 PHONO PRE-AMPLIFIER
Contents Important safety instructions.................................................................... 3 Limited warranty....................................................................................... 4 Make sure you register your purchase. Rear panel connections............................................................................ 5 Visit: http://www.cambridgeaudio.com/music-more Front panel control...................................................................................
CP1/CP2 Important safety instructions For your own safety please read the following important safety instructions carefully before attempting to connect this unit to the mains power supply. They will also enable you to get the best performance from and prolong the life of the unit: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings.
Limited warranty Ventilation Important – The unit will become hot when in use. Do not stack multiple units on top of each other. Do not place in an enclosed area such as a bookcase or in a cabinet without sufficient ventilation. Ensure that small objects do not fall through any ventilation grille. If this happens, switch off immediately, disconnect from the mains supply and contact your dealer for advice. Please ensure there is ample ventilation (at least 20cm clearance on the top, side and rear).
CP1/CP2 Rear panel connections Designed & Engineered in Britain Assembled in China L 0dB R 1 MC Turntable Ground R MC 1 MM 2 3 L 2 2 Off On 3 4 4 Cartridge Type Balance Subsonic Filter 4 5 6 1. MC input sockets (CP2 only) If your turntable uses a moving coil cartridge, connect outputs here (0.5-1mV, with 100 ohm, 220pF loading). 12V 1 3 R L MM R Output L 7 0.5 A 8 Front panel control 2.
Connections Turntable L R Power Supply Unit (PSU) Or Amplifier Technical specifications Max power consumption CP1 CP2 5W 5W MM MC Gain @ 1kHz 39dB 39dB 55dB Nominal output 300mV 300mV 300mV Sensitivity for nominal output 3.35mV 3.35mV 3.35mV THD 20Hz-20kHz <0.009% <0.009% <0.009% RIAA curve accuracy <+/-0.65dB 25hz-20kHz <+/-0.3dB 20Hz-50kHz (subsonic filter off) <+/-0.
CP1/CP2 Troubleshooting There is no power Ensure the power supply is connected securely to the unit. Ensure the power supply is fully inserted into the mains socket and is switched on. There is no sound Make sure the unit is plugged in. Check that your turntable is properly connected. Check that your speakers are properly connected. Check all connections are secure and correct amplifier input is selected. Ensure correct cartridge type has been selected (MM or MC).
Cambridge Audio is a brand of Audio Partnership Plc Registered Office: Gallery Court, Hankey Place London SE1 4BB, United Kingdom Registered in England No. 2953313 © 2015 Cambridge Audio Ltd AP34375/1 www.cambridgeaudio.
