AXA35 INTEGRATED AMPLIFIER
Contents IMPORTANT SAFET Y INSTRUCTIONS 3 RE AR PANEL CONNECTIONS 5 FRONT PANEL CONTROL S 6 REMOTE CONTROL 7 CONNECTIONS 8 This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the manufacturer. All trademarks and registered trademarks are the property of their respective owners.
AXA35 Important safety instructions For your own safety please read the following important safety instructions carefully before attempting to connect this unit to the mains power supply. They will also enable you to get the best performance from and prolong the life of the unit: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings.
SUPPLIER’S DECLARATION OF CONFORMITY (SDOC) Equipment: Integrated Amplifier Model: AXA35 Trademark: Cambridge Audio This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The responsible party in US: Company name: Audio Partnership LLC Address: 1913 N Milwaukee Ave.
AXA35 Rear panel connections Loudspeaker Terminals Impedance: Nominal 8 ohms Left Loudspeaker Right Loudspeaker Ground Ground Designed & Engineered in Great Britain Assembled in China Power AC USB 5V 500mA AXA35 Integrated Amplifier A1 A2 A3 1 1 Phono 2 A4 Rec Out Max Power Consumption: 260W Right Loudspeaker 3 AUDIO INPUTS(A1-A4) These inputs are suitable for any ‘line level’ source equipment such as the audio outputs of CD players, streaming devices such as a Chromecast Audio (RCA Pho
Front panel controls AX A35 6 AUX IN A1 / AUX 1 1 2 3 A2 4 POWER BUTTON Switches the unit between Standby mode (indicated by dim LED) and On (indicated by bright LED). Standby mode is a low power mode where the power consumption is less than 0.5 Watts. This product has APD (Auto Power Down) enabled as default. After inactivity of 20 minutes, the product will automatically switch to Standby.
AXA35 Remote Control The AXA35 is supplied with a remote control that operates this unit and its built-in tuner. In addition, some icons buttons can operate a matching AXC35 or AXC25 player. Always use Alkaline batteries. 1 2 3 4 5 6 7 8 9 0 Prog Prog Clear POWER BUTTON Switches the AXA35 between On and low power ecofriendly Standby mode. MUTE Mutes audio on the unit. Press again to cancel mute. VOLUME Increases or decreases the volume of the unit.
Connections LOUDSPEAKERS Check the impedance of your speakers. You can use types with an impedance of 8 Ohms. The red coloured speaker terminals are positive (+) and the black speaker terminals are negative (-). Make sure correct polarity is maintained at each speaker connector or the sound can become weak and “phasey” with little bass. USING BARE WIRE CONNECTIONS USING BANANA PLUGS Prepare the speaker cords for connection by stripping off approximately 10mm (3/8”) or less of the outer insulation.
AXA35 Operating Instructions Technical Specifications After making any connections to your unit, activate the AXA35 by pressing the Power button on the front of the unit. Power output 35 watts (into 8Ω) THD (unweighted) <0.01% @ 1kHz, 80% of rated power <0.15% 20Hz - 20kHz, 80% of rated power Frequency response (-3dB) 5Hz - 50kHz S/N ratio (ref 1W) >82dB (unweighted) Input impedances 47k ohms Power Amp damping factor >50 Max.
W W W.C A M B R I D G E AU D I O.C O M Gallery Court, Hankey Place London se1 4bb United Kingdom Cambridge Audio is a brand of Audio Partnership Plc. Registered in England No.