Product Info

Chapter 1: Product Description Hardware Installation
Page
11
Hardware Installation
Before configuring your router, please see the procedure below for instructions on connecting the
cnPilot Home Router in your network.
Procedure 1 Configuring the Router
1. Connect analog phone to ATA Port with an RJ11 cable.
2. Connect the WAN port to the Internet via your network’s modem/switch/router/ADSL
equipment using an Ethernet cable.
3. Connect one end of the power cord to the power port of the device. Connect the other end
to the wall outlet.
4. Push the ON/OFF button to power on the router (If available).
5. Check the Power, WAN, and LAN LEDs to confirm network connectivity.
Warning
Please do not attempt to use unsupported power adapters and do not remove power
during configuring or updating the cnPilot Home Router device. Using other power
adapters may damage the cnPilot Home Router and will void the manufacturer
warranty.
Warning
Changes or modifications not expressly approved by the party responsible for
compliance can void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.