User’s Manual RF Transmitter for Passive Keyless Model No.: TS009 There is no User’s Manual because this equipment will not be sold to enduser directly.
USER OPERATION INSTRUCTION (DRAFT) KEYLESS START SYSTEM This system uses coded radio signals to communicate with the vehicle and remote controller when the remote controller is near the vehicle such as in your pocket or purse. It allows the vehicle’s door lock/unlock, and start the engine without inserting the ignition Key. It is possible to use the control entry function. △ CAUTION ● Be sure to carry the remote controller. ● Don’t leave the vehicle when the remote controller is in it.
2. Locking doors 1. Stop the engine and get out of your vehicle with your remote controller. 2. Close all the doors. 3. Push the door handle request switch or the back door handle request switch. 4. All doors will lock. 3.Unlocking doors 1. Push the door handle request switch. ・The driver door unlock Front passenger side or back door. ・Only corresponding door unlocks. 4.OPERATING THE ENGINE ・ LOCK(Normal parking position) This position activates only lock/unlock the door functions.
For important safety information, see “Starting the engine “ in the Starting and driving section. ● The warning indicated in the instrument panel (meter) if the push engine start switch is pushed under the following condition. It is not possible to start the engine when. ・You don’t have the remote controller. ・The remote controller battery has run down. ・You have a remote controller for another vehicle. ・The engine may not start if the remote controller is placed in below.
Operating range for engine start function The operating range for starting the engine is inside the vehicle. ● The engine may not start if the remote controller is below location. ・ On the instrument panel. ・ Inside the glove box. ・ In door pocket. ・ Corner of interior compartment. ● The engine may start if the remote controller is near the door or door glass outside the vehicle . OPERATION WITH REMOTE KEYLESS ENTRY SYSTEM It is possible to lock/unlock all doors and activate the panic alarm.
2. Replace the battery with a new one. ・ Don’t touch the internal circuit and electric terminals as it could cause a malfunction. Recommended battery:CR2032 Make sure that the - side faces the bottom of the case. 3. Close the lid securely. 4. Push the buttons two or three time to check its operation. See your Suzuki dealer if you need any assistance for replacement. 1. Bring out the mechanical key. 2. Insert a flat-blade screwdriver and twist it. 3. Bring out the battery. 4. Replace the new battery. 5.
FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.