User Manual

9.user operation instruction

operation instructions for this system are contained in the motor cycle’s user manual,from

which the portions related to the system are transcribed below:

-This motor cycle is equipped with an immobilizer system.

-The immobilizer system is designed to disable the engine unless a registered key

dedicated to your motor cycle is used,and it can prevent unauthorized use of the vehicle.

-Operation procedure:

each key incorporates an unique identification code. When a key is inserted into the

ignition switch and turned to the “ON” position,the engine controller installed on the

vehicle receives the code from the inserted key and judges whether the inserted key is a

registered one or not. The engine can be activated only when the result of the judgement

is “OK”.

The driver can see the result of the judgement shown in the indicator in the instrument

Panel. In the case that the inserted key is a registered one,the indicator light stays on for

2 seconds,whereas for an unregistered key, after the initial 2 seconds the indicator blinks

as long as the ignition switch is in the “ON” position.

State of ignition switch

For a registered key

Indicator

lighting mode

For an unregistered key

-notice on handling:

The key should not suffer ant strong impact also do not leave it in a high-temerature

Environment,since electronic devices are incorporated within the key.

If you lose your key,see your HONDA dealer immediately,and bring with you all of the

Remaining keys you have,the key number plate supplied with your key and you vehicle.

Care should be taken not to lose all of keys,as in such a case the ignition unit will

Have to be replaced totally.

A duplicated key cannot be used unless the code-registering procedure is performed.

OFF

2 Sec

The engine is

activated

OFF

PAGE 1
9.user operation instruction operation instructions for this system are contained in the motor cycle’s user manual,from which the portions related to the system are transcribed below: -This motor cycle is equipped with an immobilizer system. -The immobilizer system is designed to disable the engine unless a registered key dedicated to your motor cycle is used,and it can prevent unauthorized use of the vehicle. -Operation procedure: each key incorporates an unique identification code.
PAGE 2
A maximum of four keys can be registered. If you want to have additional keys other than those you have been supplied with,follow the same procedure as required when you lose a key. Never make a change nor a modification on the immobilizer system,as it may result in disabling the engine. Changes or modifications not expressly approved of by the manufacturer for compliance could void the user’s authority to operate the device.