User Manual

9.USER OPERATION INSTRUCTION(DRAFT)
MULTI-REMOTE CONTROL SYSTEM
It is possible to lock/unlock all doors and activate the panic alarm by using the remote controller
(transmitter) from outside the vehicle.
Before locking the doors, make sure the keys is not left in the vehicle.
The remote controller can operate at a distance of approximately 33 ft(10m) from the vehicle. (The
Effective distance depends upon the conditions around the vehicle.)
As many as four remote controllers can be used with one vehicle. For information concerning the
Purchace and use of additional remote controllers, contact your NISSAN dealer.
The multi-remote controller will not function when:
-the battery is dead.
-the distance between the vehicle and the remote controller is over 33ft(10m).
The panic alarm will not activate when the key is in the ignition switch.
! CAUTION
The following conditions or occurrence will damage the remote controller.
-Do not allow the remote controller to become wet.
-Do not drop the remote controller.
-Do not strike the remote controller sharply against another object.
-Do nou place the remote controller for an extended period in an area where temperature exceed 140
degree F(60 degree C).
If multi-remote controller is lost or stolen,NISSAN recommends erasing the ID code of that controller.
This will prevent the controller from unauthorized use to unlock the vehicle.
For information regarding the eracing procedure, please contact an authorized NISSAN dealer.
HOW TO USE MULTI-REMOTE CONTROL SYSTEM
Setting hazard and horn chirp mode
This vehicle is set in hazard and horn chirp mode when you first receive the vehicle.
In hazard and horn chirp mode, when the LOCK button is pushed, the hazard indicator flashes twice
horn chirps once. When the UNLOCK button is pushed hazard indicator flashes once.
If hazard and horn chirp mode is not necessary, you can switch to normal mode by following the
switching procedure.
In normal mode, when the LOCK button is pushed, the hazard indicator flashes twice.
When the UNLOCK button is pushed, neither the hazard indicator nor the horn operates.
-Switching procedure
Push the LOCK and UNLOCK buttons on the multi-remote controller simultaneously for more than
2 seconds to switch from one mode to the other.
When pushing the buttons to set normal mode, the hazard indicator flashes 3 times.
When pushing the buttons to set hazard and horn chirp mode, the hazard indicator flashes once and
the horn chirp once.