Product Label

MAX VOC CONTENT*: 100 g/l
*Depending on color choice, colorant
containing VOC added to this product may
significantly increase VOC levels.
6 11131 29024 8
This durable, easily applied acrylic enamel is fortified with emulsified epoxy to provide maximum performance in a low gloss, water-based floor and trim finish. It incorporates
maximum color retention, breathability, alkali, water and blister resistance and adhesion into its unique formulation. This is truly the standard for quality in waterborne floor
enamels & opaque concrete sealers.
RECOMMENDED USE: Floors, patios, porches, steps, decks, playrooms, basements, wood, concrete and masonry.
SURFACE PREPARATION: AllFlor must be applied to a properly prepared sound
surface. Surfaces must be thoroughly cleaned of all dirt and dust. Dirty surfaces
should be washed with a strong detergent solution, rinsed with clean water and
allowed to dry overnight. Grease, oils and wax should be removed by solvent cleaning
to insure proper adhesion of the finish paint. All old, loose, scaly or flaking paint
must be removed back to a sound substrate before any repainting is attempted.
New concrete should be allowed to cure a minimum of 30 days before applying any
finish. Steel troweled, hard, glossy, smooth, and sealed concrete (curing agents or
sealers) should be mechanically abraded or acid etched to create a profile to obtain
proper adhesion. Water droplets should immediately penetrate concrete to determine
if coating is possible.
Note: To ensure proper surface preparation refer to SSPC-SP13/NACE
APPLICATION: Material is supplied ready to use but can be thinned up to one pint
per gallon with water for first coat on new surfaces or for spot -priming bare areas
on old finishes. Finish coat should be applied full body.
Do not paint when rain or dew is imminent.
COVERAGE: 350-400 Sq. ft./Gal on smooth, nonporous surfaces. Coverage figures
do not include material loss due to application.
DRYING TIME: Dries to touch in 2 hours at 70°F (21°C) and 50% relative humidity.
Can be recoated in 4 hours.
CLEANUP: Soap & Water
DISPOSAL: USE COMPLETELY OR DISPOSE OF PROPERLY: Dispose of in accordance
with applicable Federal, State and Local regulations.
KEEP OUT OF THE REACH OF CHILDREN. Do not take internally. Close container
after each use.
Refer to Safety Data Sheet for additional health and safety information.
Refer to Technical Data Pages on www.californiapaints.com for specific surface
preparation, application, drying and further information.CAUTION: All floor enamels
are more slippery when the surface becomes wet or contaminated by dirt, oils, food
or beverage residues, or other debris. To help reduce the possibility of slipping on a
dry, clean floor, add one pint of Duralux Marine Non-Skid Additive M747 per gallon
of floor enamel before application. To attain the best possible skid resistance, coated
areas must be kept dry, properly cleaned and maintained.
Do not add solvents, oils or colors in oil, or mix with other paint types. Do not apply when air or surface temperature is below 50° F
or when drying conditions are poor. Keep from freezing. Do not use on garage floors. Hot tires or the weight of a vehicle can cause
loss of adhesion. Do not apply over water, glass or other silicate concrete hardeners. Not recommended on areas utilizing heavy duty
lift trucks.
53013 Light Gray
32 FL OZ
0.95 L
53013-4 REV 09.25.20
CAS NO CHEMICAL INGREDIENTS
7732-18-5 Water
107-21-1 Ethylene Glycol
1309-37-1 Iron (III) Oxide
13463-67-7 Titanium dioxide
14808-60-7 Silicon Dioxide
1332-58-7 Kaolinite
N/A+ Latex Resin Solid
+Contents partially unknown