RCD 266 4x 75WATT LOCATION OF PARTS AND CONTROLS 3 1 15 9 RCD 266 2 7 5 11 14 16 6 26 4x 75WATT 8 13 10 19 20 21 22 23 24 27 12 25 RCD 266 4 (1-6) 4x 75WATT 1. POWER ON/OFF ( ) 2. FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/FADER / TA SEEK/PI SOUND/ RETUNE/MASK DPI/EON/BEEP/TA VOL/ADJ TIME/AUDIO DSP (SEL) 3 1 15 9 5 11 14 16 6 26 3. VOL UP/VOL DOWN FOR BASS/TREBLE/BALANCE/FADER 4. PRESET STATIONS (1,2,3,4,5,6) 5. ‘AF’ function (ALTERNATIVE FREQUENCIES) 6.
ISO CONNECTOR RCA Jack Line Out: Red (right) White (left) ISO CONNECTOR B ANTENNA 1 3 5 7 2 4 6 8 CONNECTOR CONNECTOR A 5 7 A 4. MEMORY +12V LINE OUT 4 8 L (WHITE) R (RED) 5. AUTO ANTENNA OUTPUT 7. +12V (TO IGNITION KEY) FUSE 10A 8. GROUND Note: (connector A no. 7) wire must be connected by car ignition key in order to avoid that car battery becomes weak when the car will be not used for long period. CONNECTOR B 1. REAR RIGHT SPEAKER (+) 2. REAR RIGHT SPEAKER (-) 3. FRONT RIGHT SPEAKER (+) 4.
TO SUPPORT THE UNIT 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 4 3 4 Dashboard 6 5 8 2 10 7 5 1 9 UNIT RELEASE CASE DASH BOARD HEX NUT LOCK WASHER PLAIN WASHER CAR BODY REAR SUPPORT STRAP TAPPING SCREW M5 X 15 HEX BOLT 4 6 Detaching and attaching the front panel The front panel of this unit can be detached in order to prevent the unit from being stolen. FOLDING DOWN AND DETACHING/ATTACHING THE FRONT PANEL Before detaching the front panel, be sure to press the button (1) OFF first.
OPERATION INSTRUCTIONS 1. POWER ON/OFF ( ) By pressing this key, the unit is on and off. This unit is turned on by pressing any key. 2. FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/FADER / TA SEEK/PI SOUND/RETUNE/ MASK DPI/EON/BEEP/TA VOL/ADJ TIME/AUDIO DSP (SEL) Turning the VOL knob Right or Left (3), you can adjust VOL/BASS/TREB/BAL/FAD. To select other functions, press the SEL (2) button shortly until the desired functions is shown on the display.
2 sec. SEL TA SEL PI PI VOL RETUNE SEL MUTE / SOUND RETUNE S / RETUNE L VOL EON 2 sec. MODE (2) 2 sec. press the VOL When SEL button/ SEEK for more than 2 seconds, it is activated as selecting mode of these function. TA ALARM 2SEL sec. TA PI RETUNE RETUNE S / RETUNE L radio or PTY groups if the TA or SEL SEL SEL VOL When function switched on theVOL radio switches to traffi ALL c/ DPI TA EON PI is SEL MASK SEL the SEL SEL RETUNE PTY function has been activated.
USING THE RDS FUNCTION What is RDS? The RDS (Radio Data System) is a digital information system developed by the EBU (European Broadcast Union). Piggy-backed on normal FM broadcasts, RDS offers a variety of information services and automatic retuning functions for RDS-compatible car stereos. In 1988, RDS became available in the United Kingdom, France, West Germany, Ireland and Sweden. Test transmissions are being conducted in many other european countries.
14. MUTE BUTTON ( ) Press this button to mute the sound at once. Press again to return to previous volume level. 15. LCD DISPLAY The Liquid Crystal Display will display the current state of the unit. 16. OPEN THE FRONT PANEL Press button and the front panel will open. CD/MP3/WMA CONTROL LOCATION OF PARTS TRACK/SEARCH BUTTON (11) FORWARD AND REVERSE TRACK SEARCH (or changing songs) Press the SKIP button ( or ) during play to go to the desired track(song). ....REVERSE ....
• • • • Press “VOL” knob longer than 2 sec. The song which has same character you selected is displayed. VOL VOL / VOL VOL ” knob, VOL With “VOL you can select the song you want. Press “VOL” knob, then the song you selected will start. Connecting it to Portable MP3 Player 25. USB Port Using USB cable to connect Your Portable MP3 Player. 26. MULTI-MEDIA CARD (MMC) / SD CARD SLOT Support MP3 ID3 format music only.
TECHNICAL SPECIFICATIONS CD/MP3/WMA PLAYER SECTION Signal to Noise Ratio Channel Separation Frequency Response > 60 dB > 50 dB (1kHz) 20 Hz - 20 kHz TUNER FM Frequency Range Intermediate Frequency Sensitivity Stereo Separation Signal to Noise Ratio Channel Step 87.5-108 MHz 10.7 MHz 2.8 µV 30 dB 50 dB 50 kHz LINE-OUT Output Impedance 1.5V (max.) 10k Ohm GENERAL Power Supply Speaker Impedance Output Power 12 V DC (10.8-15.