Installation Manual

Ecco User Guide

Introduction

The requirement for reliable, always-on PCS phone coverage continues to

increase dramatically. However, it is not unusual to encounter areas within a

residence or other building where it’s difficult to receive consistent coverage.

The Ecco

is a powerful and sophisticated cost-effective signal repeater that

augments PCS coverage. This simple-to-use device is specifically designed for

use in a residence, small office or other in-building application. Ecco has

advanced software that adjusts various performance parameters based on the

ever-changing RF environment and its compact form factor is aesthetically

designed to blend into any home or office decor.

Product Placement

Installing the Ecco is simple and requires no tools, test equipment or RF

knowledge. The Ecco must be located by a window with access to a standard

household outlet. To receive maximum product performance, you’ll need to

locate the window location with the strongest signal. Using your current Sprint

PCS phone (make sure it’s powered on), check the signal strength meter at each

window location. At the window location with the strongest signal, place the Ecco

repeater on the window sill, or nearby table, counter or other convenient location

with the LED display facing indoors.

Power button

Tx indicator

Band Select button

Low battery indicator

Current Band display

Signal Strength display

PAGE 1
Ecco User Guide Introduction The requirement for reliable, always-on PCS phone coverage continues to increase dramatically. However, it is not unusual to encounter areas within a residence or other building where it’s difficult to receive consistent coverage. The EccoTM is a powerful and sophisticated cost-effective signal repeater that augments PCS coverage. This simple-to-use device is specifically designed for use in a residence, small office or other in-building application.
PAGE 2
Product Configuration Plug in the AC adapter to the outlet and connect to the Ecco repeater. Turn on the device by pressing the “Power” button. Consult the table below to identify the appropriate signal band (“A”, “B”, “C”, “D”, “E”, or “F”) for your Sprint PCS market. Insert US map with applicable frequency bands Now select the appropriate PCS signal band on the Ecco by pressing the “Band Select” button until the desired band is lit up in the “Current Band” display.