User's Manual

STG-836

Instruction Manual

WARNINGS

For customer in the U.S.A and Canada

• You are cautioned that changes or modifications not expressly approved

by the part responsible for compliance could void the user’s authority to

operate the equipment.

• This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

• Operation is subject to the following two conditions:

1) This device may not cause interference and

2) This device must accept any interference, including interference that

may cause undesired operation of the device.

• This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment. End users must follow the specific operating

instructions for satisfying RF exposure compliance. This transmitter must

not be co-located or operating in conjunction with any other antenna or

transmitter.

PAGE 1
STG-836 Instruction Manual WARNINGS For customer in the U.S.A and Canada • You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. • This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
• The lithium coin battery inside this product contains Perchlorate. The following statement is required by the State of California, USA: Perchlorate Material – special handling may apply. For customer in Europe • This equipment has been tested and found to comply with the limits set out in the R&TTE Directive.
PAGE 3
USAGE Switching on STG-836 • STG-836 will turn on automatically and start operating once the battery is inserted. Inserting battery 1. Turn over STG-836 and unscrew the 4 screws. 2. Lift the bottom cover away from the top cover.
PAGE 4
3. Pull the battery out from the holder.
PAGE 5
4. To replace a new battery, slide the battery into the battery holder from the position as shown on picture below. Make sure the positive side of battery is facing up. Slide battery from this side Positive Side of battery facing -up 5.