Heat Prep Cable Heating Tool User Guide TM
Heat Prep™ Cable Heating Tool Engineered to apply just the right amount of heat to make cable jacket material more pliable, the Heat Prep CHT ensures solid connections every time and reduces wear and tear on technicians’ hands. To Charge the CHT 1. Plug the 9-volt power adapter (supplied) into the power jack on the bottom center of the tool. The single LED charge indicator light will turn red to indicate that it is charging. 2.
use in about one minute, the first red light on the CHT will illuminate, followed a few seconds later by the second red indicator light and finally the third red indicator light as the tool warms to 190°F (88°C). When the center light turns green, the tool has reached the right level of heat and is safe and ready to use. 2. Fully insert the prepared cable (stripped and with braids folded back as you normally would) into the open end of the CHT and wait at least 10 seconds before removing cable. 3.
207 Middlesex Avenue Post Office Box 373 Chester, CT 06412-0373 USA Toll-free: 1-800-394-4046 Phone: 1-860-526-4337 Fax: 1-860-526-2291 www.CablePrep.com © 2017 Ben Hughes Communication Products Company. All rights reserved. Cable Prep, the Cable Prep logo, Tools You Trust, the Cable Prep Tools You Trust logo, the CPT logo, FOCUS, the FOCUS logo, Gator, the Gator logo, Super CPT, and Wing Ding are registered and common law trademarks of Ben Hughes Communication Products Company.