Adirondack Upright Chair C03 C.R. Plastic Products 341 Lorne Ave. East Stratford Ontario N5A 6S4 Toll Free: 800-490-1283 Fax: 519-271-8544 Web Site crpproducts.
PARTS LIST: A. Seat (with back legs) Qty: 1 D. Stringer Qty: 1 B. Right Arm (with front leg) Qty: 1 E. Back C. Left Arm (with front leg) Qty: 1 Qty: 1 HARDWARE LIST: 1. Screws Qty: 32 Note: Read these instructions carefully before assembling. Tools required: #2 Phillips driver and power drill. Find a clean, smooth area on which to work, such as a carpet, in order to avoid scratching the plastic surfaces. It might be helpful to use the shipping carton in step 1 and 2.
Step 1: Set the Seat (A) with attached back legs on the shipping carton with the Seat facing down. Using the factory-installed screw as a pivot, rotate the back legs approximately 300o, until the ends are parallel with the long angled edge. Secure each leg with an additional Screw in the counter-sunk holes provided. Item A 1 Description Seat Screws Qty 1 4 Step 2: Set the Seat (A) on the shipping carton as shown. Insert two Screws through the holes in the Seat that are closest to the front of the chair.
Step 4: Stand the assembly on its legs and secure the Arm (C) to the Back Leg (A) using the upper 2 holes on the Back Leg (the back edge of the arm should be flush with the edge of the Back Leg). Use a screw into the third hole on the Back Leg (A) to secure the small triangular block to the Back Leg (A). Repeat for Right Arm B. Item 1 Description Screws Qty 6 C A Step 5: Note: there are four locations to attach the Back (E).