Manual NÜO AIR 42272 | 42328
NÜO AIR Manual Information Features GENERAL FEATURES NÜO AIR (ref. no.: 42272 and 42328) -- Maximum security proximity reader for contactless MIFARE Plus® and NFC cards. -- Reader status indicated via acoustic-light display. -- Communications with authentication and data encryption using AES and 3DES -- IP67 protection and IK08 impact ratings. -- Assembled in an embedded case using a screw-less hidden fastener with an automatic interlock. -- Optional stainless steel casing for surface mounting.
NÜO AIR Manual Information Features Wiring TYPE OF WIRING AND WIRING DISTANCE: The NÜO AIR reader incorporates a male overhead connector. NÜO AIR is supplied with a 3.5 metre piped cable with 4 wires (2 twisted pairs) and a female connector at one end to correctly connect it. The other end of the piped cable is connected to a single door controller or to the corresponding Wili following the simple colour coding.
NÜO AIR Manual Installation NÜO AIR The NÜO AIR reader can be flush mounted in various environments. The various installation methods are described below: FLUSH MOUNTING 1) Remove the reader from the flush mount support using the detachable clip. Insert it and pull down. 2) Using a level, make a hole in the wall measuring 92 x 92 mm and 51 mm deep. Pass the connecting cable through and grout the hole. Plaster 3) Insert the flush mount support and connect the assembly.
NÜO AIR Manual Installation Equipment NÜO AIR part To mount the reader on a plasterboard wall, the support should be screwed using CL82Z-3.1 x 16 countersunk screws (NOT INCLUDED). SURFACE MOUNTING The NÜO AIR reader can be surface mounted by using the surface support kit. Instructions for assembly are as follows: 1) Mark the position of the 4 screws used to fasten the surface support to the wall. 2) Drill and place the wall plugs for the screws. Screws should have a diameter of 3.
NÜO AIR Manual Installation NÜO AIR NÜO AIR readers can be directly connected to two types of devices depending on the architecture of the installation: -- Connection to a Wili. -- Connection to a single door controller. The connection to be made for both types of devices is exactly the same. The colour code must be followed. For more detailed information, consult the equipment manuals referenced earlier.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipmentÿ Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.