Manual NÜO AWA 42222 | 42294
NÜO AWA Manual Introduction Features GENERAL FEATURES NÜO AWA (Ref. no. 42222 and 42294) --Biometric reader with optical fingerprint sensor and multi-spectral imaging technology. --Identifies up to 1,000 users --Maximum security proximity reader for contactless MIFARE Plus® and NFC cards. --Proximity card reader from a distance of 3 to 4 cm.
NÜO AWA Manual Introduction Features Technical Specifications TECHNICAL SPECIFICATIONS NÜO PASS: INPUT VOLTAGE 24 VDC STAND BY POWER 2.8 W - 100 mA MAXIMUM POWER 3.9 W - 140 mA READING DISTANCE 3 - 4 cm FINGERPRINT SENSOR TYPE Multispectral SENSOR RESOLUTION 500 dpi 300 x 400 Pixels MAX. NO. FINGERPRINTS 1,000 to 10,000 (with DC1+BIO controller) COMMUNICATIONS BYBUS RS-485 Full-Duplex BLUETOOTH® Fully Low Energy BLE compliant, Smart v4.
NÜO AWA Manual Introduction Features Wiring TYPE OF WIRING AND WIRING DISTANCE: The NÜO AWA reader incorporates a male overhead connector. NÜO AWA is supplied with a 3.5 metre piped cable with 4 wires (2 twisted pairs) and a female connector at one end to correctly connect it. The other end of the piped cable is connected to a single door controller or to the corresponding Wili following the simple colour coding. NÜO AWA + A B BY B U S Orange O/W Green G/W 3.
NÜO AWA Manual Installation NÜO AWA FLUSH MOUNTING The NÜO AWA reader can be flush mounted in various environments. Follow the detailed instructions below to install it correctly: 1) Remove the reader from the flush mount support using the detachable clip. Insert the clip and pull down. 2) Using a level, make a hole in the wall measuring 92 x 92 mm and 51 mm deep. Pass the connecting cable through and grout the hole. Plaster 3) Insert the flush mount support and connect the assembly.
NÜO AWA Manual Installation NÜO AWA To flush mount the reader into a plasterboard wall, the support should be screwed using CL82Z-3.1 x 16 countersunk screws (NOT INCLUDED). SURFACE MOUNTING The NÜO AWA reader can be surface mounted by using the surface support kit. The assembly instructions are as follows: 1) Mark the position of the 4 screws used to fasten the surface support to the wall. 2) Drill and place the wall plugs for the screws. Screws should have a diameter of 3.
NÜO AWA Manual Installation NÜO AWA WIRING NÜO AWA readers can be directly connected to two types of devices depending on the architecture of the installation: --Connection to a Wili --Connection to a single door controller The connection to be made for both types of devices is exactly the same. The colour code must be followed. For more detailed information, consult the equipment manuals referenced earlier.
NÜO AWA Manual 9
NÜO AWA Manual 10
NÜO AWA Manual 11
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipmentÿ Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.