User manual NÜO SURF 41761 | 42054
NÜO Surf Manual Information Features GENERAL FEATURES NÜO FLUX (ref. no.: 42054 and 41761) -- Maximum security proximity reader for contactless MIFARE Plus® and NFC cards. -- Reader status indicated via acoustic-light display. -- Communication encrypted with AES AND 3DES encryption algorithms. -- Operating temperature from -10 °C to 50 °C for indoor installations. -- References according to black and white model: NÜO SURF 41761 42054 -- White: 42054 -- Black: 41761 REGULATIONS ISO/IEC 14443 A and B.
NÜO Surf Manual Information Features TECHNICAL SPECIFICATIONS NÜO SURF: INPUT VOLTAGE 24VDC STAND BY POWER 0.9 W - 32 mA MAXIMUM POWER 1.8 W - 66 mA CPU 32-bit ARM Microprocessor READING DISTANCE 4-6 cm COMMUNICATIONS BYbus RS-485 SECURITY Dynamic encryption CONNECTION IP67 connector + 3.5 m ByBus 2 cable ALARM 2 sound levels incorporated for granted access and denied access. Automatically regulated according to environmental conditions.
NÜO Surf Manual Information Features TECHNICAL SPECIFICATIONS READER DIMENSIONS 120 x 46 x 20 mm (height x width x depth) -- Wall mount for reader ACCESSORIES -- Bag with accessories: -- Screws and wall plugs for surface mounting.
NÜO Surf Manual Installation NÜO SURF TYPE OF WIRING AND WIRING DISTANCE: The NÜO FLUX readers incorporate a 4-pin male overhead connector and the corresponding female connector which joins 3 metres of piped cable with 4 wires (2 twisted pairs). This means that the installation and wiring to then connect the reader to a single door controller or to the corresponding Wili are both very simple. + A B BY B U S Orange O/W Green G/W 3.
NÜO Surf Manual Installation NÜO SURF Surface mounted 1) Anchor base to wall, levelled. To do this, mark the location of support holes and drill at the diameter corresponding to the wall plugs provided. Do not forget to pass the power and communication cables through: X 2) Pass the reader connection cable through the hole made for such purpose: X X X The head of the figure in the drawing should be pointing up. Recommended height for installation is between 1.2 and 1.5 m.
NÜO Surf Manual Installation Wiring NÜO SURF readers can be directly connected to two types of devices depending on the architecture of the installation: -- Connection to a Wili. -- Connection to a single door controller. The connection to be made for both types of devices is exactly the same. The colour code must be followed. For more detailed information, consult the equipment manuals referenced earlier.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipmentÿ Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.