RF In Stadium Transmission System User’s Manual Networking Transmitter Model: ST100NT-P 2017-03-30
Insert Batteries 6 Alkaline C-cell batteries are required. Duracell or Energizer brand are recommended. Remove cover plate and carefully insert batteries into holder, observing polarity, and secure firmly with Velcro straps. Replace all 8 screws and hand tighten. Set Frequency Switches 3 & 4 on the interconnect board between the two radio modules can be used to select between 4 frequencies, according to the following chart. The unit must be power cycled for the change to take effect.
Regulatory Statements Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Warning (Part 15.21) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.