Warranty

ManualsBrandsBuyers Products Company ManualsOutdoor Power Equipment22.5 in. 100 lbs. Capacity Grounds Keeper Walk Behind Spreader

Assembly Instructions

3042650 Steel Frame

Walk Behind Broadcast Spreader

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone (440) 974-8888 • Fax (800) 841-8003

www.buyersproducts.com

FULL ONE YEAR WARRANTY

Manufacturer will repair, or at manufacturer’s discretion will replace any part of this salt spreader which proves to be defective in workmanship or material

under normal use for a period of one year from the date of delivery to the original purchaser. Any cost incurred in returning the product to the supplier is the

responsibility of the consumer.

EXCLUSIONS

Manufacturer shall not be liable for special, incidental, or consequential damages, or for damages resulting from lack of necessary maintenance, from misuse,

abuse, acts of God, or alteration of the product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above

limitation or exclusion may not apply to you.

Summary of content (4 pages)

PAGE 1
9049 Tyler Blvd. • Mentor, Ohio 44060 Phone (440) 974-8888 • Fax (800) 841-8003 www.buyersproducts.com Assembly Instructions 3042650 Steel Frame Walk Behind Broadcast Spreader FULL ONE YEAR WARRANTY Manufacturer will repair, or at manufacturer’s discretion will replace any part of this salt spreader which proves to be defective in workmanship or material under normal use for a period of one year from the date of delivery to the original purchaser.
PAGE 2
Rear Deflector Assembly Rain Cover And Hardware Kit Are Not Shown C. Carefully insert the LowerFigure Linkage into the Restrictor Plate 3 underneath the Hopper as shown. (The Figure 2 Lower Linkage has two bent ends & the Upper Linkage has one threaded end).
PAGE 3
Step E Attach Control Plate Assembly To Frame Using M6x40 Bolts F. Attach Control Handle Assembly to Frame Using M6x40 Bolts G. Remove Control Handle from Assembly, Insert Upper Linkage Step E into Control Handle, Reattach Control Handle Attach Control Plate Assembly Rod To Be Flat (Parallel To The Ground) This End Of Rod To Be Facing Upward To Frame Using M6x40 Bolts I. Set the Restrictor Plate Fully Open and the Control Handle to "30" (as shown) First Jam Nut H.
PAGE 4
9049 Tyler Blvd. • Mentor, Ohio 44060 Phone (440) 974-8888 • Fax (800) 841-8003 www.buyersproducts.com Parts List 2 1 12 3 14 4 5 13 8 9 15 10 6 17 16 18 7 11 Bill of Material ITEM PART NO. QTY 1 2 3 4 5 6 7 8 3021435 3010874 3042704 3042705 3012702 3012696 3035272 3008142 3011734 3009160 1 1 1 1 1 1 1 1 DESCRIPTION Frame Handle Hopper Assembly Hopper Restrictor Plate Assembly Spinner Disc Axle Deflector Assembly Rear Deflector Assembly Control Handle Assembly 4 ITEM PART NO.