Thank you for purchasing the BUY DEEM product. Please read this manual and related illustrations carefully before using this product to grant you access to complete support from BUY DEEM.
NOTICE A IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always bs followed, including the following: + Read all Instructions. + Do not touch hot surfaces. Uss handles or knobs.
NOTICE A Notice This product is designed for household use only, and the warranty by the manufacturer only covers product defects and household faults. The manufacturer is not responsible for any consequences or faults caused by commercial use, unsuitable use, or allure to follow the Instructions, because such allures and damages are beyond the warranty. Pisa check whether the voltage displays on the product specification labs! Is consistent with the main voltage before use.
UNDERSTANDING PRODUCT USING PRODUCT Product Structures 1 3 Removable Scale filter Lid Handle 2 ud 4 Pour Spout I] : Handle Kettle Body 7 Power On/Off Switch with light 8 Power Base 8 Power cord First use 1. Remove all packaging, labels and accessories inside and outside the kettle before the first use. 2. Water billed for the first two or threat times should be poured out for the purposes of cleaning. Then wipe the exterior of the kettle with & dry cloth.
USING PRODUCT USING PRODUCT Uss guilelessness 1. Open the lid of kettle 4. Place the kettle on the power base + Pull the lid handle upwards ta open the lid of kettle. + Make sure to place the power base on a flat, clean, heat-resistant surface. = An exclusive power base Is needed for the kettle. = Please dry off the bottom of the kettle. + Do not use the kettle when theta Is no water Insides It. 2. Add an appropriate amount of water Plug In + Do not add any water when the kettles is on the bass.
CLEANING & MAINTAINING Cleaning and maintenance Cleaning of kettle 1. Disconnect the prows plug 2. Clean the Inside of kettle with a wet sponge after It cools down. Note: Do not soak the kettle, power base, power cord or plug In water (the electronics connectors on the bottom and the base of the kettle should not be exposed to water). Descaling 1. The kettle needs to be descaled regularly, once a month at least. If the water quality is poor, the frequency should be increased 2.
SIMPLE TROUBLESHOOTING Simple Troubleshooting Fault phenomenon Reason analysis Troubleshooting After Installation, the district kettle dos not work after the switch Is pressed Power supply ls disconnected | Power supply Is disconnected After putting the lentils body The kettles body and the base | on the wire seat, rotate and are not connected In pace. adjust the position to confirm t hat iris connected in place.