Owners manual

4325 HAMILTON MILL RD • BUFORD, GA 30518 • 1-800-241-7219 (USA AND CANADA) • FAX 800-438-3788

2015 Ford F150

Extended Cab

Trail Armor

Rocker

Panel & Sill Plate Combo

Set

Set Part #14081

BW14081 Rev-0 05-11-2018

For complete tment info visit: www.bushwacker.com

• Cleaning Cloth

• To claim a warranty, you must provide

Proof of Purchase.

LIMITED LIFETIME WARRANTY AGAINST

ANY MANUFACTURING DEFECTS

TOOLS FOR EASY INSTALLATION:

Included in Hardware Kit:

STEP 1 - PRIOR TO INSTALLATION

Bushwacker only approves installing the Trail Armor according to

these written instructions with the hardware provided. WARNING:

Failure to install according to these instructions will invalidate the

warranty. This includes, but is not limited to using alternative installa-

tion methods, hardware, or materials. DO NOT USE: Loctite, Super-

Glue, or similar products on the hardware or the ares.

NOTE: Ambient temperature and part temperature must be at

least 60°F (16°C) for proper adhesion.

Fit: Verify the t of the Trail Armor to vehicle. (Some ling, sanding,

or cutting may ne necessary to ensure proper t.)

Painting: (Optional) if paint is desired it must be done prior to

installing Trail Armor on vehicle. Clean outer surface with a good

grade degreaser. DO NOT USE LACQUER THINNER OR ENAMEL

REDUCER AS A DEGREASER. Wipe outer surface thoroughly with

a tack rag prior to paint. Application of plastic adhesion promoter for

TPO plastic as per your paint system manufacturer’s

recommendations is required. Paint Trail Armor using a high quality

enamel, or polyurethane automotive paint. If painting edge trim (not

recommended), use a ex additive.

ALCOHOL

PREP

PAD

8 pcs.

PAGE 1
STEP 1 - PRIOR TO INSTALLATION A) Bushwacker only approves installing the Trail Armor according to these written instructions with the hardware provided. WARNING: Failure to install according to these instructions will invalidate the warranty. This includes, but is not limited to using alternative installation methods, hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar products on the hardware or the flares.
PAGE 2
Rear Side Panel Installation Procedure (Driver’s Side) 1 Toward Rear of Vehicle Toward Front of Vehicle 2 Open vehicle doors. Clean all dirt and debris from vehicle door sills and rocker panel. Use supplied alcohol wipes where part will attach. Peel back roughly 3” of red tape liner from the pieces of tape on the back side of rear part. Make sure red tape liner will be accessible when part is attached to truck. 3 Set part in place on vehicle. Remove all red tape liners.
PAGE 3
Front Side Panel Installation Procedure (Driver’s Side) 4 Toward Rear of Vehicle Toward Front of Vehicle 5 Peel back roughly 3” of red tape liner from the pieces of tape on the back side of rear part. Make sure red tape liner will be accessible when part is attached to truck. 6 Set part in place on vehicle. Remove all red tape liners. Apply FIRM pressure to mounting locations to affix to truck.