BEA FCC ID: BIOLOGIST [pe — 1-87 DIGITAL DESCRIPTION AND TEST REPORT IS-87 DIGITAL Instruction Manual. This document is the property of B.E.A. and is furnished on the condition that it is not to be disclosed, reproduced in whole or in part, or used for manufacture for anyone other than B.E.A.
FCC 11: BISECT? om IS-87 HIGH MOUNTING INDUSTRIAL MOTION SENSOR INSTRUCTION MANUAL August 1997 Inc. ® 300 South Main Street » Pittsburgh, PA 15215 « USA Tel. 412-782-5150 « Fax 412-782-5154 » For product information Tel. 800 3 BEA INC.
The 1-87 is a High Mounting Industrial motion detector operating on microwave technology, and is superior in detecting vehicles and pedestrians in the most severe environments. It can be configured to operate as a bidirectional sensor. or as a unidirectional sensor. In the unidirectional mode. it can detect either approaching traffic or departing traffic by simply flipping a switch on the front of the sensor. The IS-87 is impervious to adverse weather conditions.
FOC ID. GIBBET 3. The same bracket can be used for ceiling mount and wall mount. Be sure to allow adequate room for ceiling and wall clearance when selecting a location. Note that dimension A below will vary according to the mounting angle of the sensor. For ceiling mounts, dimension A can be a maximum of 6.50" and for wall mounts, dimension A can be a maximum of 6.25". WALL MOUNT ~~ 3.19" a.567 — 3. Use the mounting bracket as a template to locate holes on surface of mounting location.
4. Make the following wire connections at the point of wire termination: A. Unscrew the back trap B. Remove the terminal block C. Run the cable through the plastic cable lock D. Connect the cable according to the diagram E. Tighten the plastic cable lock F. Screw the back trap Back View of 1-87 sea | (OOS .
ADJUSTMENTS FCC ID: G9Bisy 1. Remove screw-in plug to set adjustments. The switch position will function as follows: Front View of 1-87 Red LED ~ Retry Output Pt Sensitivity adjustment Clockwise maximum; Counter Clockwise minimum P2 Relay hold time Clockwise maximum = 13 sec. Counter Clockwise minimum = 0.5 sec.
TROUBLESHOOTING COMMON PROBLEMS: A. Red LED does not come on when sensor is approached: I. Increase sensitivity clockwise at front of sensor and test sensor again. If LED comes on, rung sensor as necessary. if it does not come on. proceed with following steps. 2. Check to determine if in unidirectional or bidirectional mode (Dip Switch 1). If in bidirectional mode go to step 3. If in unidirectional mode ensure that the sensor is set for proper direction of travel (Dip Switch 3). 3.