Instruction Manual

ManualsBrandsBullard ManualsSafetyS2

TacSight™ S2 Thermal Imager

User Manual

Congratulations

Congratulations on the purchase of your new TacSight S2 Thermal Imager

from Bullard. The TacSight S2 Thermal Imager combines advanced thermal

imaging technology with our expertise in impact and element resistant

engineered materials to bring you the most durable thermal imager on the

market. The TacSight S2's innovative, compact design and logical, easy-to-

use interface presents the latest innovation in thermal imaging for law

enforcement, tactical, patrol and surveillance applications.

Some of the many uses for your TacSight S2 Thermal Imager

include:

• Vehicle Pursuits and Fugitive Searches

• Perimeter Surveillance

• Search and Rescue

• Hidden Compartments in Vehicles

• Marine and Ground Surveillance

• Environmental Law Enforcement

• Officer Safety

Bullard stands ready to support your department with industry leading

thermal imager training materials and Law Enforcement Thermographers

Association (L.E.T.A.) certified instructors.

NOTE

To help us better serve you, please fill out the warranty card

enclosed with your TacSight S2 Thermal Imager.

Read all instructions and warnings before using this product. Failure to

observe this information could result in death or serious injury.

WARNING

Lens

Power Button

Battery

LCD Screen

Side Strap

Rear Boot

Polycarbonate

Display Cover

Lens Bezel

Figure 1

Display Brightness

Control Switch

Summary of content (4 pages)

PAGE 1
TacSight™ S2 Thermal Imager User Manual Congratulations Congratulations on the purchase of your new TacSight S2 Thermal Imager from Bullard. The TacSight S2 Thermal Imager combines advanced thermal imaging technology with our expertise in impact and element resistant engineered materials to bring you the most durable thermal imager on the market.
PAGE 2
Use and Operation Power Button Figure 2 Power To turn on the TacSight S2 Thermal Imager, simply depress the large, dark gray power button under the LCD display (Figure 2). Upon pressing the power button, the thermal imager will initiate a short calibration sequence. The image will appear in approximately five seconds. To turn off power, depress the power button. CAUTION During use, avoid pointing the camera directly at the sun as this may damage the microbolometer detector elements.
PAGE 3
TacSight S2 Thermal Imager User Manual Care Instructions Service The TacSight S2 Thermal Imager requires little maintenance. For best results, periodically: If your Bullard Thermal Imager is not performing properly, please contact Bullard Customer Service at 877-BULLARD (285-5273). Outside the US & Canada, call 1-859-234-6611. Describe the problem to the Bullard representative as completely as possible.
PAGE 4
Warranty Bullard warrants to the original purchaser that the TacSight S2 Thermal Imager, transmitter, MobileLink, Mobile Command Center, Powerhouse and Battery Chargers if applicable, are free of defects in materials and workmanship under intended use and service for a period of one (1) year from date of manufacture.