Installation Guide

ManualsBrandsBuilding 36 Technologies ManualsElectronicsWireless Water Sensor

Table Of Contents

Water Sensor Installation Guide

ADC-S40-W

In the box

• ADC-S40-W Water Sensor

• Mounting bracket

• CR123 battery

• Installation guide

• Screw (pan head x2)

• Cable tie

NOTE: The rope attachment and probe attachment are sold separately.

Installation

Installing the Alarm.com Water Sensor

1. Place the water sensor near the area where you want to detect water.

a. The water sensor detects water on the top or bottom of the device.

2. Remove the battery tab from the water sensor

(OPTIONAL) Installing the water sensor with rope attachment

1. Connect the rope attachment to the water sensor.

2. Remove the battery tab from the water sensor.

3. Mount the water sensor to a wall or pipe near the desired monitoring area using the mounting

bracket or cable tie provided.

4. Place the rope attachment on the floor around the potential leak source or around the

perimeter of the monitored area. The rope attachment can detect water along its entire length.

(OPTIONAL) Installing the water sensor with probe attachment

1. Connect the probe attachment to the water sensor.

2. Remove the battery tab from the water sensor.

3. Mount the water sensor to a wall or pipe near the desired monitoring area using the mounting

bracket or cable tie provided.

4. Place the end of the probe attachment in its desired location and mount it using the screw

provided. Make sure the prongs on the end of the probe attachment are within the area where

you want to detect water.

Adding the water sensor to the Z-Wave network

Adding using SmartStart

NOTE: An Alarm.com account is required for this process. Power on and add devices one at a time.

1. Power on the Hub or panel.

2. Log in to MobileTech.

3. Find the customer account.

4. Add the device using SmartStart and follow the on-screen instructions.

5. Scan the device’s QR code (found on the box or sensor).

6. Remove the battery tab from the sensor.

7. If you have already removed the battery tab, press the button to wake up the device.

Summary of content (4 pages)

PAGE 1
Water Sensor Installation Guide ADC-S40-W In the box • • • • • • ADC-S40-W Water Sensor Mounting bracket CR123 battery Installation guide Screw (pan head x2) Cable tie NOTE: The rope attachment and probe attachment are sold separately. Installation Installing the Alarm.com Water Sensor 1. Place the water sensor near the area where you want to detect water. a. The water sensor detects water on the top or bottom of the device. 2.
PAGE 2
a. When the network LED on the sensor turns solid green, the sensor has been successfully added. 8. Ensure you see the device on your account. a. It may take up to 2 minutes for the device to appear on your account. Adding manually TIP: For best results, we recommend having the Hub or panel in the same room as the water sensor you are adding. 1. Remove the battery tab from the water sensor. 2. Put the Hub or panel into Add mode. Refer to the Hub or panel documentation for more information. 3.
PAGE 3
LED reference guide LED Network Alert LED Status Solid for 5 seconds Blink 3 times Solid for 3 seconds Blink 10 times Solid for 3 seconds Blinks 3 times Both Flash twice Description Add successful Delete successful Device resetting Problem detected Sensor transitioned from dry to wet or wet to dry Attachment plugged in or attachment removed Power up Notices FCC This device complies with part 15 of the FCC rules.
PAGE 4
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause Harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.