Product Manual

ManualsBrandsBuilding 36 Technologies ManualsElectronicsCommunicating Smart Water Valve Module, Radio Transceiver

Smart Water Valve

Product Manual

Caution:

• Adhere to all relevant local codes and ordinances as they pertain to the Smart Water

Valve. You are required to consult local plumbing codes and have appropriate licensing

for the installation of this device.

• It is recommended to test valve functionality prior to installation.

• Never insert fingers or any other item into the valve. Inserting objects into the valve may

result in damage or injury.

• The Smart Water Valve should only be powered using the supplied power adapter

(Supports mains voltage: 100-240 VAC ~50/60 HZ). DO NOT APPLY POWER TO THE

SMART WATER VALVE UNTIL THE UNIT IS FULLY ASSEMBLED.

Summary of content (7 pages)

PAGE 1
Smart Water Valve Product Manual Caution: • • • • Adhere to all relevant local codes and ordinances as they pertain to the Smart Water Valve. You are required to consult local plumbing codes and have appropriate licensing for the installation of this device. It is recommended to test valve functionality prior to installation. Never insert fingers or any other item into the valve. Inserting objects into the valve may result in damage or injury.
PAGE 2
Box Contents: • • • • • • • Smart Water Valve Control Unit Valve Actuator Power Adapter Wall Bracket Wall Anchors and Screws (x2) Cable Ties (x3) Additional Parts Requirements: Installation of the Smart Water Valve will require additional fittings to connect the ends of the valve to the pipe. The type of fittings needed will depend on the pipe material, industry standards and applicable plumbing codes.
PAGE 3
Location: The Smart Water Valve must be installed: NOTE: Water shutoff valves and leak detection devices should NEVER be installed on a fire suppression system. • • • • • • In a dry, indoor location. Downstream from the main shut-off valve on the desired water supply line. With the Control Unit located above the valve. Use drip loops wherever possible to avoid damaging the electronics in the event of a leak. In compliance with all local plumbing and electrical codes. Within 20 feet of a wall outlet.
PAGE 4
10. Add the Smart Water Valve to the Z-Wave network (see “Adding the Valve to the ZWave Network”). Adding the Smart Water Valve to the Z-Wave Network: TIP: For best results, we recommend bringing the Z-Wave controller into the area where the Smart Water Valve is installed. 1. Put the Z-Wave controller in ADD mode. Refer to controller documentation for more information. 2. Press the Networking [Insert Radio Icon] button on the side of the Smart Water Valve control unit to begin the ADD process.
PAGE 5
Resetting the Smart Water Valve to Factory Default Settings: Caution: Resetting the Smart Water Valve to its factory default settings will cause the device to remove itself from the network and restore all user settings to their default values. Local Reset: Press and hold the Networking [Insert Radio Icon] button for 15 seconds. All three LEDs will blink for five seconds and the device will restart.
PAGE 6
Notices: FCC This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. –and– 2. This device must accept any interference received, including Interference that may cause undesired operation. NOTE: Changes and Modifications not expressly approved by Building 36 can void your authority to operate this equipment under Federal Communications Commissions rules.
PAGE 7
Radiation Exposure Statement The device has been found to be compliant to the requirements set forth in CFR 47 Sections 2.1091 and Industry Canada RSS-102 for an uncontrolled environment. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. Le dispositif a été jugé conforme aux exigences énoncées dans les articles 47 CFR 2.